BMA150-0330SB0003 BOSCH, BMA150-0330SB0003 Datasheet - Page 24

• Manufacturer Part Number: BMA150-0330SB0003
• Description: Daughter Board
• Manufacturer: BOSCH

Specifications of BMA150-0330SB0003

• Silicon Manufacturer: Bosch
• Application Sub Type: Accelerometer - Three-Axis
• Kit Application Type: Sensing - Motion / Vibration / Shock
• Silicon Core Number: BMA150
• Kit Contents: Board

Synchronization of read-out sequence has several advantages:
3.5.3 New_data_x, new_data_y, new_data_z
These bits (New_data_x (02h, 0), new_data_y (04h, 0), new_data_z (06h, 0)) are flags which
are turned at 1 when acceleration registers have been updated. Reading acceleration data MSB
or LSB registers turns the flags at 0. The flag value can be read by microprocessor.
3.5.4 Al_version, ml_version, chip_id
al_version (address 01h, bit 7-4) and ml_version (address 01h, bit 3-0) are used to identify the
chip revision. These codes are programmed with metal layer.
chip_id (address 00h, bit 2-0) is used by customer to be able to recognize BMA150. This code is
fixed to 010b.
Rev. 1.5
© Bosch Sensortec GmbH reserves all rights even in the event of industrial property rights. We reserve all rights of disposal such
as copying and passing on to third parties. BOSCH and the symbol are registered trademarks of Robert Bosch GmbH, Germany.
Note: Specifications within this document are subject to change without notice.
−
−
−
it enables a constant phase shift between acceleration conversion and its corresponding
digital value read by microprocessor
it reduces interface communication by avoiding over-sampling.
potential noise due to serial interface activity perturbation would always be generated
during a less critical phase of the conversion cycle. The maximum delay advised to start
read out acceleration data is 20µs after INT high (window 0 - 80µs).
Triaxial, digital acceleration sensor
Data sheet
BMA150
Page 24
Bosch Sensortec
30 May 2008