EVK-CONNECT-010 DENSITRON, EVK-CONNECT-010 Datasheet - Page 5

• Manufacturer Part Number: EVK-CONNECT-010
• Description: CONNECTION BOARD, FOR 1498857/8, EVK
• Manufacturer: DENSITRON

Specifications of EVK-CONNECT-010

• Svhc: No SVHC (18-Jun-2010)
• Rohs Compliant: YES
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Symbol Definition
D17-D9：These pins are 9-bit bi-directional data bus to be connected to the MCU’s data bus.
D17-D10： These are for command and data inputs (8bit parallel interface).
CSB：These pins are CSB pins for master and slave driver IC. This pin is the chip select
input. The chip is enabled for MCU communication only when CSB is pulled low.
CPU： Selects the CPU type.
PS： Selects parallel/Serial interface type.
RDB： For an 80-system bus interface, read strobe signal(active low).
WRB：For an 80-system bus interface, write strobe signal (active low).
RESB：Reset SEPS525F(active low).
VCC : External Column Driving Power Supply.
VDD : Logic power supply.
VSS
HV：External Column Driving Power Supply.
LV：Logic power supply.
GND：Power supply ground.
Note1:
Note2:
Note3:
Product No.
Copyright ©2006 DENSITRON TECHNOLOGIES plc. All rights reserved. – Proprietary Data
When using SPI, fix it to VDD or VSS level.
For a 68-system bus interface, read/write select.
When using SPI, fix it to VDD or VSS level.
DOTCLK and floating VSYNCO.
Please ground the unused data pins
If you do not use RGB Interface, please ground VSYNC, HSYNC, Enable,
If you do not use VDDIO, please connect it to LV (VDD).
For a 68-system bus interface, bus enable strobe (active high).
: Power supply ground.
Low: 80-series CPU
High: 68-Series CPU
Low: serial
High: parallel.
Low: Write
High: Read.
DD-160128FC-1A/2A
REV. B
Page
5 / 17