DS00161 Microchip Technology, DS00161 Datasheet - Page 22

• Manufacturer Part Number: DS00161
• Description: Technical Library CD-ROM
• Manufacturer: Microchip Technology

Specifications of DS00161

• Tool Type: Manuals
• Lead Free Status / RoHS Status: na

ICEPIC™ User’s Guide
DS51103B-page 16
1.7.3
1.7.4
Inserting the Daughter Board
1. Connect the extender cable to the daughter board.
2. The daughter board will have several factory-preset jumper links. Ensure
3. Connect the daughter board to the motherboard via the two DIN41612
4. Ensure that the emulator crystal (XTAL) is securely inserted.
5. Slide the front panel back into position on the pod, ensuring that the
6. Replace the top of the pod and secure it together with the two pod
7. Connect the RS-232 serial cable from the back of the pod to an available
8. Connect the 9 VDC power supply.
9. Connect the extender cable into the target application.
Removing the Daughter Board
1. Disconnect the power supply from the pod.
2. Disconnect the RS-232 cable from the pod.
3. Remove the two screws that hold the pod together.
4. Remove the top of the pod, followed by the front plate (labeled ICEPIC-
5. Carefully ease the daughter board (the top PCB) from the two DIN41612
that these links are set correctly for your application. Refer to Appendix B
or the links.txt file for more information.
connectors.
extender cable passes through the slot and that the POWER and RUN
LEDs are visible.
screws.
COM port on your PC.
16CXXX).
connectors.
Note:
Note:
Note:
Do not exceed the voltage specifications for the emulator pod
or any probe device as described in the respective data sheets.
Pin 1 of the extender cable is colored “red.” Pin 1 of the DIP
header connector is adjacent to the “red” side of the cable.
The connectors are keyed. In other words, they will only fit
together in one direction. This helps to ensure correct polarity
of the two boards.
 2000 Microchip Technology Inc.