453391604 Molex Inc, 453391604 Datasheet - Page 14

• Manufacturer Part Number: 453391604
• Description: CONN PLUG WIRE TERMINATION 10POS
• Manufacturer: Molex Inc
• Series: HandyLink™ 45593r

Specifications of 453391604

• Connector Style: Plug
• Connector Type: Handylink
• Number Of Positions: 10
• Mounting Type: Through Hole
• Termination: Solder
• Contact Finish: Gold
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Features: -
• Contact Finish Thickness: -
• Other names: 045339-1604; 45339-1604; 453391604

REVISION:
DOCUMENT NUMBER:
A
6.3.2 Encapsulation
NOTE: The sealant or cover should enclose the cavities under the latches, whether or not wires are soldered to the latches. Omission
The next step after soldering is to pre-seal or encapsulate the back end of the connector and hold the wires in place using a silicone
sealant or a low-pressure Macro-melt polyamide adhesive molding. The sealant will prevent accidental shorting between adjacent
terminals and discourage intrusion of over-mold resin into the terminal and latch cavities. An illustration of the pre-seal coverage is
shown below. Care must be taken to ensure that no encapsulant enters the terminal or latch cavities.
An alternate method is to combine one or more molded ‘covers’ to block entire sections where void circuits are present, then use a
pre-seal or encapsulant to hold the wires separate. This is illustrated below.
of this step would allow the final over-mold resin to extrude into cavities in the housing that could disable latch and terminal function.
SD-45339-001
EC No:
DATE:
ECR/ECN INFORMATION:
UCP2006- 1391
2005/12/13
APPLICATION SPECIFICATION
TITLE:
CREATED / REVISED BY:
HANDYLINK™
M. Simmel
Figure 7.
Encapsulated plug connector
Figure 8.
Covered and encapsulated plug connector
HANDYLINK™I/O CONNECTOR SYSTEM
APPLICATION SPECIFICATION
Marc Simmel
CHECKED BY:
TEMPLATE FILENAME: PRODUCT_SPEC[SIZE_A](V.1).DOC
APPROVED BY:
Joe Comerci
14 of 26
SHEET No.