CV500RM211 Omron, CV500RM211 Datasheet - Page 33

• Manufacturer Part Number: CV500RM211
• Description: Programmable Logic Controller
• Manufacturer: Omron

Specifications of CV500RM211

• Peak Reflow Compatible (260 C): No
• Leaded Process Compatible: No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

4-4
4-4-1 Rack or Trough Installation
Installation Precautions
1, 2, 3...
Be sure to follow the precautions described above under the heading “one-way
pulling” and eliminate any bends or twists in the cable after installation.
Install the cord or cable on the rack (or in the trough) being careful not to apply
too much tension, bending, or twisting, and allowing a little slack (about 10
mm/m).
Do not install the cord or cable on top of or between power supply wires. The
power wires might cut into the cord or cable or pinch it, increasing the pulling
tension. Allow at least 10 mm between the Optical Fiber Cord or Cable and
power supply wires or install the Optical Fiber Cord or Cable off to the side,
as shown below.
1. Pull or lay the cable from the starting point in the first direction (1).
2. Remove the remaining cable from the reel and pile it in figure-eight layers
3. Install the remaining cable in the second part of the installation route, taking
near the starting point (2).
care not to tangle or twist the cable (3).
Optical Fiber Cable
Saddle
Saddle
(The cable should not be too loose, nor too tight.)
Rack
Starting point
(3)
Saddles
2 m
Section 4-4
(1)
(2)