BRT-THG-2-100 BANNER ENGINEERING, BRT-THG-2-100 Datasheet - Page 3
BRT-THG-2-100
Manufacturer Part Number
BRT-THG-2-100
Description
TAPE, RETRO REFLECTIVE, 50MMX2.5M
Manufacturer
BANNER ENGINEERING
Specifications of BRT-THG-2-100
Roll Length
2.5m
Tape Type
Reflective
Width
50mm
Length
2.5 m
Reflectivity Factor
0.7
Standards
CE Marked
Temperature, Operating, Maximum
60°C
For Use With
Photoelectric Sensors
Lead Free Status / Rohs Status
RoHS Exempt Product
SFCDT-4A1 PICO-GUARD Controller
•
•
•
•
•
•
•
•
•
•
Remote Display
Banner Engineering Corp. • Minneapolis, MN U.S.A. • bannerengineering.com • Tel: 763.544.3164
Two Universal Safety Stop Interface (USSI) inputs which can be used to
cascade controllers or monitor other safeguarding devices (with either
Banner OSSDs or relay contact outputs).
Selectable functions:
Two solid-state safety outputs to control 24V dc loads
Fast 13 millisecond output response time for the optical channels and
7 millisecond output response time for the USSIs
Removable terminal blocks speed and simplify wiring
Sleek, compact, robust housing
Auxiliary, Weak Signal and Fault outputs for non-safety monitoring
RS-232 status and diagnostic output (diagnostic/system status and excess
gain estimation software included)
35 mm DIN-rail mount
User-friendly status indicators on the controller’s face
This DIN-mountable unit provides an additional readout of the controller’s
status indicators.
- Selectable Auto/Manual Power-up – Determines whether the System will
- Selectable Trip/Latch Output – Determines whether the System will
- External Device Monitoring (EDM) – Allows the System to monitor the
- Optical Channel Controls – Individual optical channels can be switched to
require a manual reset to proceed to Run mode when power is applied.
require a manual reset to turn on the OSSD outputs after an optical
channel has been blocked.
status of external devices, such as MPCEs (One- or Two-Channel
Monitoring, or OFF).
ON or OFF for applications that require fewer than four operating optical
channels. (At least one channel must be set to ON.)
Note: For general hookup information, see pages 300-302.
PICO-GUARD
™
Systems
Controller
45