LPC2378FBD144 NXP Semiconductors, LPC2378FBD144 Datasheet - Page 37

• Manufacturer Part Number: LPC2378FBD144
• Description: MCU 32BIT ARM7, 10/100, USB, CAN
• Manufacturer: NXP Semiconductors

Specifications of LPC2378FBD144

• Core Size: 32bit
• No. Of I/o's: 104
• Program Memory Size: 512KB
• Ram Memory Size: 58KB
• Cpu Speed: 72MHz
• Oscillator Type: External, Internal
• No. Of Timers: 4
• No. Of Pwm Channels: 6
• Digital Ic Case: RoHS Compliant
• Controller Family/series: LPC23xx
• Rohs Compliant: Yes

NXP Semiconductors
LPC2377_78
Product data sheet
7.27.1 EmbeddedICE
7.27.2 Embedded trace
7.27.3 RealMonitor
The EmbeddedICE logic provides on-chip debug support. The debugging of the target
system requires a host computer running the debugger software and an EmbeddedICE
protocol convertor. The EmbeddedICE protocol convertor converts the Remote Debug
Protocol commands to the JTAG data needed to access the ARM7TDMI-S core present
on the target system.
The ARM core has a Debug Communication Channel (DCC) function built-in. The DCC
allows a program running on the target to communicate with the host debugger or another
separate host without stopping the program flow or even entering the debug state. The
DCC is accessed as a coprocessor 14 by the program running on the ARM7TDMI-S core.
The DCC allows the JTAG port to be used for sending and receiving data without affecting
the normal program flow. The DCC data and control registers are mapped in to addresses
in the EmbeddedICE logic.
The JTAG clock (TCK) must be slower than
interface to operate.
Since the LPC2377/78 has significant amounts of on-chip memories, it is not possible to
determine how the processor core is operating simply by observing the external pins. The
ETM provides real-time trace capability for deeply embedded processor cores. It outputs
information about processor execution to a trace port. A software debugger allows
configuration of the ETM using a JTAG interface and displays the trace information that
has been captured.
The ETM is connected directly to the ARM core and not to the main AMBA system bus. It
compresses the trace information and exports it through a narrow trace port. An external
Trace Port Analyzer captures the trace information under software debugger control. The
trace port can broadcast the Instruction trace information. Instruction trace (or PC trace)
shows the flow of execution of the processor and provides a list of all the instructions that
were executed. Instruction trace is significantly compressed by only broadcasting branch
addresses as well as a set of status signals that indicate the pipeline status on a cycle by
cycle basis. Trace information generation can be controlled by selecting the trigger
resource. Trigger resources include address comparators, counters and sequencers.
Since trace information is compressed the software debugger requires a static image of
the code being executed. Self-modifying code can not be traced because of this
restriction.
RealMonitor is a configurable software module, developed by ARM Inc., which enables
real-time debug. It is a lightweight debug monitor that runs in the background while users
debug their foreground application. It communicates with the host using the DCC, which is
present in the EmbeddedICE logic. The LPC2377/78 contain a specific configuration of
RealMonitor software programmed into the on-chip ROM memory.
All information provided in this document is subject to legal disclaimers.
Rev. 5 — 17 June 2010
1
⁄
Single-chip 16-bit/32-bit microcontrollers
6
of the CPU clock (CCLK) for the JTAG
LPC2377/78
© NXP B.V. 2010. All rights reserved.
37 of 68