HEF4046BT NXP Semiconductors, HEF4046BT Datasheet - Page 5

• Manufacturer Part Number: HEF4046BT
• Description: IC, 4000 LOCMOS, SMD, 4046, SOIC16
• Manufacturer: NXP Semiconductors

Specifications of HEF4046BT

• Pll Type: VCO
• Frequency: 7MHz
• Supply Voltage Range: 3V To 15V
• Digital Ic Case Style: SOIC
• No. Of Pins: 16
• Operating Temperature Range: -40°C To +70°C
• Svhc: No SVHC (18-Jun-2010)
• Operating: RoHS Compliant
• Supply Current: 750µA
• Rohs Compliant: Yes
• Base Number: 4046

Philips Semiconductors
Phase comparator 2 is an edge-controlled digital memory
network. It consists of four flip-flops, control gating and a
3-state output circuit comprising p and n-type drivers
having a common output node. When the p-type or n-type
drivers are ON, they pull the output up to V
V
on the positive-going edges of the signals at SIGN
COMP
not of importance.
If the signal input frequency is higher than the comparator
input frequency, the p-type output driver is maintained ON
most of the time, and both the n and p-type drivers are
OFF (3-state) the remainder of the time. If the signal input
frequency is lower than the comparator input frequency,
the n-type output driver is maintained ON most of the time,
and both the n and p-type drivers are OFF the remainder
of the time. If the signal input and comparator input
frequencies are equal, but the signal input lags the
comparator input in phase, the n-type output driver is
maintained ON for a time corresponding to the phase
difference. If the comparator input lags the signal input in
phase, the p-type output driver is maintained ON for a time
corresponding to the phase difference. Subsequently, the
voltage at the capacitor of the low-pass filter connected to
this phase comparator is adjusted until the signal and
January 1995
SS
Phase-locked loop
respectively. This type of phase comparator only acts
IN
. Therefore, the duty factors of these signals are
Fig.5 Typical waveforms for phase-locked loop employing phase comparator 2 in locked condition.
DD
or down to
IN
and
5
comparator inputs are equal in both phase and frequency.
At this stable point, both p and n-type drivers remain OFF
and thus the phase comparator output becomes an open
circuit and keeps the voltage at the capacitor of the
low-pass filter constant.
Moreover, the signal at the phase comparator pulse output
(PCP
a locked condition. Thus, for phase comparator 2 no phase
difference exists between the signal and comparator
inputs over the full VCO frequency range. Moreover, the
power dissipation due to the low-pass filter is reduced
when this type of phase comparator is used because both
p and n-type output drivers are OFF for most of the signal
input cycle. It should be noted that the PLL lock range for
this type of phase comparator is equal to the capture
range, independent of the low-pass filter. With no signal
present at the signal input, the VCO is adjusted to its
lowest frequency for phase comparator 2 . Figure 5 shows
typical waveforms for a PLL employing this type of phase
comparator in locked condition.
OUT
) is a HIGH level which can be used for indicating
Product specification
HEF4046B
MSI