Z80-058 Harwin Inc, Z80-058 Datasheet - Page 2

• Manufacturer Part Number: Z80-058
• Description: Crimping, Stripping, Cutting Tools & Drills DATAMATE CRIMP POSITIONER
• Manufacturer: Harwin Inc
• Type: Crimp Toolr

Specifications of Z80-058

• Product: Crimping, Stripping & Cutting Tools & Drills
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

The Hand crimp tool M22520/2-01 consists of a basic hand tool, which should be used with a
positioner.
The contact is correctly crimped when the tool is free to open at the fully closed position, i.e.,
when the ratchet releases. The tool cannot be opened without completing the cycle.
1.
2.
3.
4.
5.
6.
7.
1.
2.
IS-01
Issue: 3
Check that the tool is in the open position. Remove the safety clip from the positioner guide
(do not discard).
Insert the Positioner into the positioner guide and turn it 90° in the direction shown on the
tool, until the bayonet pins lock.
Install the safety clip back into the positioner guide (optional).
Check Table 1 for the correct crimp tool setting of the wire size you wish to crimp.
Remove the safety clip from the selector knob (do not discard).
Lift and turn the selector knob until the correct crimp tool setting is lined up with the “Sel.
No.” arrow. Lower the selector knob, ensuring the locating peg lines up with a notch.
Install the safety clip back into the selector knob.
Ensure that the wire to be crimped is within the specified range of sizes for the contact and
the crimp tool. Failure to use the specified wire size will result in poor quality crimps and
possible tool damage.
Cut the end of the cable to be terminated so that there is a clean cut end (Figure A). Strip
the cable to the correct length (Figure B) using a PTFE Wire stripper, preferably with
adjustable rotating cutter. This should result in all the strands laying together neatly. If the
lay of the strands is disturbed, it may be re-imposed with a slight twist.
M80-01100XX
M80-04000XX
M80-19400XX
M80-01300XX
M80-04100XX
M80-19500XX
M80-05500XX
Ø1.10mm max (22-28 AWG)
Ø1.80mm max (18-20 AWG)
K36XX-46
Contact
Date: 03.10.07
Clean cut
Figure A
C/Note: 9874
Power Crimp
Power Crimp
Crimp Type
Large Bore
Small Bore
GENERAL INFORMATION
CRIMPING PROCEDURE
TOOL PREPARATION
Wire Gauge
(AWG)
22
24
26
28
20
18
18
Table 1
RIGHT
Stranding
19/0.15
19/0.26
Variable
7/0.15
7/0.12
19/0.2
(mm)
7/0.2
Figure B
2.00 ±0.15mm (M80-XXX)
3.75 ±0.25mm (K36XX)
Crimp Tool
Setting
6
6
6
6
8
8
8
WRONG
pull-off force
Minimum
12.5N
140N
142N
50N
44N
25N
85N
Page 2 of 3