RM4000 Tektronix, RM4000 Datasheet - Page 6

• Manufacturer Part Number: RM4000
• Description: Benchtop Oscilloscopes Rackmount Kit for DPO4000/MSO4000
• Manufacturer: Tektronix

Specifications of RM4000

• Equipment Type: Rackmount Kit
• Accessory Type: Rackmount
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With: DPO4000 and MSO4000 Series Oscilloscopes

UltraTrak RM4000
Figure 3.
Hard Drive
Mounting Holes
(total of 4)
7. Insert screws through the holes in the Drive Carrier and into the
8. Slide the assembled Drive Carrier back into the UltraTrak and press
9. Repeat steps 2 through 7 until all of your hard drives are installed.
bottom of the hard drive. Snug each screw. Be careful not to over
tighten.
the handle forward to lock the Drive Carrier.
UltraTrak Drive Carrier
Handle
If you plan to operate your UltraTrak with less than four
hard disk drives, install all four Drive Carriers into the
Chassis, even if they are not holding a drive.
The Drive Carrier Handle must be locked or the disk drive
will not power up.
Power Connector
Insert the carrier into
the chassis this way
6
Important
Caution
ATA
Connector