LIS331DLH STMicroelectronics, LIS331DLH Datasheet - Page 31

• Manufacturer Part Number: LIS331DLH
• Description: Board Mount Accelerometers DGTL OUTPT MTN SEN MEMS ULTRA LO PWR
• Manufacturer: STMicroelectronics

Specifications of LIS331DLH

• Sensing Axis: X, Y, Z
• Acceleration: 2 g, 4 g, 8 g
• Digital Output - Number Of Bits: 16 bit
• Supply Voltage (max): 3.6 V
• Supply Voltage (min): 2.16 V
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 40 C
• Digital Output - Bus Interface: I2C, SPI
• Shutdown: Yes
• Package / Case: LGA-16
• Output Type: Digital
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

LIS331DLH
7.10
7.11
7.12
7.13
Table 36.
OUT_X_L (28h), OUT_X_H (29)
X-axis acceleration data. The value is expressed as two’s complement.
OUT_Y_L (2Ah), OUT_Y_H (2Bh)
Y-axis acceleration data. The value is expressed as two’s complement.
OUT_Z_L (2Ch), OUT_Z_H (2Dh)
Z-axis acceleration data. The value is expressed as two’s complement.
INT1_CFG (30h)
Table 37.
Table 38.
ZDA
YDA
XDA
AOI
6D
ZHIE
ZLIE
YHIE
AOI
STATUS_REG description (continued)
INT1_CFG register
INT1_CFG description
Z axis new data available. Default value: 0
(0: a new data for the Z-axis is not yet available;
1: a new data for the Z-axis is available)
Y axis new data available. Default value: 0
(0: a new data for the Y-axis is not yet available;
1: a new data for the Y-axis is available)
X axis new data available. Default value: 0
(0: a new data for the X-axis is not yet available;
1: a new data for the X-axis is available)
AND/OR combination of Interrupt events. Default value: 0.
(See
6 direction detection function enable. Default value: 0.
(See
Enable interrupt generation on Z high event. Default value: 0
(0: disable interrupt request;
1: enable interrupt request on measured accel. value higher than preset threshold)
Enable interrupt generation on Z low event. Default value: 0
(0: disable interrupt request;
1: enable interrupt request on measured accel. value lower than preset threshold)
Enable interrupt generation on Y high event. Default value: 0
(0: disable interrupt request;
1: enable interrupt request on measured accel. value higher than preset threshold)
6D
Table
Table
39)
39)
ZHIE
Doc ID 15094 Rev 3
ZLIE
YHIE
YLIE
Register description
XHIE
XLIE
31/38