WM8983GEFL/V Wolfson Microelectronics, WM8983GEFL/V Datasheet - Page 92

• Manufacturer Part Number: WM8983GEFL/V
• Description: Audio CODECs Mbl Multimedia CODEC w/ 1W Speaker Driver
• Manufacturer: Wolfson Microelectronics

Specifications of WM8983GEFL/V

• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Package / Case: QFN-32
• Minimum Operating Temperature: - 25 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

WM8983
w
Table 64 Jack Detect Register Control Bits
Switching on/off of the outputs is fully configurable by the user. Each output, OUT1, OUT2, OUT3
and OUT4 has 2 associated enables. OUT1_EN_0, OUT2_EN_0, OUT3_EN_0 and OUT4_EN_0 are
the output enable signals which are used if the selected jack detection pin is at logic 0 (after de-
bounce). OUT1_EN_1, OUT2_EN_1, OUT3_EN_1 and OUT4_EN_1 are the output enable signals
which are used if the selected jack detection pin is at logic 1 (after de-bounce).
The jack detection enables operate as follows:
All OUT_EN signals have an AND function performed with their normal enable signals (in Table 51).
When an output is normally enabled at per Table 51, the selected jack detection enable (controlled
by selected jack detection pin polarity) is set 0; it will turn the output off. If the normal enable signal is
already OFF (0), the jack detection signal will have no effect due to the AND function.
During jack detection if the user desires an output to be un-changed whether the jack is in or not,
both the JD_EN settings, i.e. JD_EN0 and JD_EN1, should be set to 0000.
If jack detection is not enabled (JD_EN=0), the output enables default to all 1’s, allowing the outputs
to be controlled as normal via the normal output enables found in Table 51.
R9 (09h)
GPIO control
R13 (0Dh)
REGISTER
ADDRESS
5:4
6
3:0
7:4
BIT
JD_SEL
JD_EN
JD_EN0
JD_EN1
LABEL
00
0
0000
0000
DEFAULT
Pin selected as jack detection input
00 = GPIO1
01 = GPIO2
10 = GPIO3
11 = Reserved
Jack Detection Enable
0 = disabled
1 = enabled
Output enables when selected jack
detection input is logic 0.
[0]= OUT1_EN_0
[1]= OUT2_EN_0
[2]= OUT3_EN_0
[3]= OUT4_EN_0
Output enables when selected jack
detection input is logic 1
[4]= OUT1_EN_1
[5]= OUT2_EN_1
[6]= OUT3_EN_1
[7]= OUT4_EN_1
DESCRIPTION
PD, Rev 4.3, May 2010
Production Data
92