ENW-89818C2JF Panasonic, ENW-89818C2JF Datasheet - Page 15

• Manufacturer Part Number: ENW-89818C2JF
• Description: Bluetooth / 802.15.1 Modules & Development Tools CC2560 HCI module no antenna
• Manufacturer: Panasonic

Specifications of ENW-89818C2JF

• Interface Type: I2C, SPI, UART
• Data Rate: 4 Mbps
• Operating Voltage: 3.3 V
• Board Size: 6.5 mm x 9 mm
• Operating Temperature Range: - 20 C to + 70 C
• Output Power: 10.5 dBm
• Technology/ Type: HCI Module
• Processor Series: CC2560
• For Use With/related Products: EVAL-PAN1315
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

CLASSIFICATION
SUBJECT
CUSTOMER’S CODE
PAN1315
10.
11.
PANASONIC ELECTRONIC DEVICES EUROPE GMBH
HOST CONTROLLER INTERFACE
AUDIO/VOICE CODEC INTERFACE
The codec interface is a fully-dedicated programmable serial port that provides the logic
to interface to several kinds of PCM or I2S codecs.
schemes required by Bluetooth specification – Log PCM (A-Law or μ-Law) and Linear (CVSD). In
addition, module also supports transparent scheme
• Two voice channels
• Master / slave modes
• µ-Law, A-Law, Linear, Transparent coding schemes
• Long and short frames
• Different data sizes, order, and positions.
• High rate PCM interface for EDR
The CC2560 incorporates one UART module dedicated to the host controller interface
(HCI) transport layer. The HCI interface transports commands, events, ACL, and
synchronous data between the Bluetooth device and its host using HCI data packets.
The UART module supports H4 (4-wires) protocol with maximum baud rate of 4 Mbps
for all fast clock frequencies.
After power up the baud rate is set for 115.2 kbps, irrespective of fast clock frequency.
The baud rate can thereafter be changed with a vendor specific command. The
CC2560 responds with a Command Complete Event (still at 115.2 kbps), after which
the baud rate change takes place. HCI hardware includes the following features:
• Receiver detection of break, idle, framing, FIFO overflow, and parity error conditions
• Transmitter underflow detection
• CTS/RTS hardware flow control
The interface includes four signals: TXD, RXD, CTS, and RTS. Flow control between
the host and the CC2560 is byte-wise by hardware.
Flow control is obtained by the following:
When the UART RX buffer of the CC2560 passes the “flow control” threshold, it will set
the UART_RTS signal high to stop transmission from the host.
When the UART_CTS signal is set high, the CC2560 will stop its transmission on the
interface. In case HCI_CTS is set high in the middle of transmitting a byte, the CC2560
will finish transmitting the byte and stop the transmission.
CLASS 1 or 2 BLUETOOTH MODULE
PRODUCT SPECIFICATION
PANASONIC’S CODE
ENW89818C2JF
:
PAN1315 supports all voice coding
No.
DS-1315-2400-102
PAGE
DATE
www.pedeu.pansonic.de
23.05.2011
15 of 41
REV.
1.03