STM32100B-EVAL STMicroelectronics, STM32100B-EVAL Datasheet - Page 9
![MCU, MPU & DSP Development Tools STM32 ARM Value Line Eval Board](/photos/15/93/159330/lpstm32-9_sml.jpg)
STM32100B-EVAL
Manufacturer Part Number
STM32100B-EVAL
Description
MCU, MPU & DSP Development Tools STM32 ARM Value Line Eval Board
Manufacturer
STMicroelectronics
Specifications of STM32100B-EVAL
Processor To Be Evaluated
STM32F100VB
Data Bus Width
32 bit
Interface Type
RS-232, USB, I2C, SPI, USART
Operating Supply Voltage
3.3 V
Silicon Manufacturer
ST Micro
Core Architecture
ARM
Core Sub-architecture
Cortex - M3
Silicon Core Number
STM32
Silicon Family Name
STM32F1xx
Kit Contents
Board
Features
IrDA Transceiver,
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
UM0841
2.3
2.4
2.5
2.6
Clock source
Two clock sources are available on the STM32100B-EVAL board for the STM32F100VBT6
microcontroller and RTC.
Reset source
The reset signal of the STM32100B-EVAL board is active low and the reset sources include:
Table 4.
Audio
The STM32100B-EVAL board supports playback based on a speaker on the board. This
can be disabled or enabled by jumpers JP1 and JP2. The audio volume can be adjusted
using the potentiometer RV1. See
Table 5.
Serial Flash
A 128 Mbit serial Flash connected to SPI1 of the STM32F100VBT6 microcontroller shares
the same SPI port with the MicroSD Card using a different chip select signal. Serial Flash
chip select is managed by the standard I/O port PD9.
Jumper
Jumper
X1, 32 KHz crystal for embedded RTC
X2, 8 MHz crystal with socket for the STM32F100VBT6 microcontroller. It can be
removed from the socket when the internal RC clock is used.
Reset button B1
Debugging tools from JTAG connector CN3
Daughterboard from CN5
Embedded ST-LINK
Bootloader_Reset from RS-232 connector CN10
JP5
JP1
JP2
Reset jumper
Audio jumpers
Bootloader_Reset signal from the RS-232 connector CN10 pin 1 (DCD) is connected
to RESET# of the STM32F100VBT6 when JP5 is closed.
This configuration is used for the boot loader application only.
Default setting: Not fitted
Audio power amplifier TS4990IST is forced on standby mode when JP1 is fitted.
Default setting: Not fitted
The DAC _OUT(PA4) is connected to speaker circuit when JP2 is closed.
Default setting: Fitted
Doc ID 16533 Rev 2
Section 4.4: Audio amplifier
Description
Description
Hardware layout and configuration
volume.
9/41