V2DIP1-64 FTDI, V2DIP1-64 Datasheet - Page 19
![Interface Modules & Development Tools USB Vinculum-II 64 Pin Mod 1 USB Port](/photos/15/88/158855/vinculum_sml.jpg)
V2DIP1-64
Manufacturer Part Number
V2DIP1-64
Description
Interface Modules & Development Tools USB Vinculum-II 64 Pin Mod 1 USB Port
Manufacturer
FTDI
Datasheet
1.V2DIP1-64.pdf
(27 pages)
Specifications of V2DIP1-64
Interface Type
USB, Serial, UART, FIFO, SPI
Data Bus Width
Serial, 8 bit
Operating Supply Voltage
5 V
Product
Interface Modules
For Use With/related Products
VNC2-64
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
3.8 Debugger Interface
The purpose of the debugger interface is to provide access to the VNC2 silicon/firmware debugger. The
debug interface can be accessed via the appropriate pin on the DIL connector or more easily, it can be
accessed by connecting a debug module to the J3 connector. This debug module will give access to the
debugger through a USB connection to a PC via the Integrated Development Environment (IDE). The IDE
is a graphical interface to the VNC2 software development tool-chain and gives the following debug
capabilities through the debugger interface:
The Debugger Interface, and how to use it, is further described in the following applications Note
Vinculum-II Debug Interface Description
3.8.1 ignal Description - Debugger Interface
Table 3.10 shows the signals and pins description for the Debugger Interface pin header J3
J3-1
J3-2
J3-3
J3-4
J3-5
J3-6
Table 3.10 - Signal Name and Description – Debugger Interface
Pin No.
Flash Erase, Write and Program.
Application debug - application code can have breakpoints, be single stepped and can be halted.
Detailed internal debug - memory and register read/write access.
RESET#
PROG#
Name
GND
IO0
5V0
-
Copyright © 2010 Future Technology Devices International Limited
On PCB
Name
PRG#
[Key]
RST#
DBG
GND
VCC
PWR Input
V2DIP1-64 VNCL2-64Q Development Module Datasheet Version 1.0
Type
Input
Input
PWR
I/O
-
Can be used by an external device to reset the
VNCL2. This pin is also used in combination with
PROG# and the UART interface to program
firmware into the VNC2.
This pin is used in combination with the RESET#
pin and the UART interface to program firmware
into the VNC2.
5.0V module supply pin. This pin can be used to
provide the 5.0V input to the V2DIP1-64 from the
debugger interface when the V2DIP1-64 is not
powered from the USB connector (VBUs) or the
DIL connector pins J1-12, J1-13 and J1-19 and
J3-6.
Not connected. Used to make sure that the debug
module is connected correctly.
Module ground supply pin
Debugger Interface
Description
Document Reference No.: FT_000165
Clearance No.: FTDI# 154
18