RTV5818-300ML MG Chemicals, RTV5818-300ML Datasheet - Page 3

• Manufacturer Part Number: RTV5818-300ML
• Description: ADHESIVE SEALANT SIL FAST CURE
• Manufacturer: MG Chemicals
• Series: RTVr
• Type: Potting Compound, 1 Partr

Specifications of RTV5818-300ML

• Features: Marine Application
• Product: Silicones
• Size: 10 oz
• Application: Use in assembly applications requiring high productivity, also good for marine applications
• Chemical Component: Silicone
• Color: Translucent
• Dielectric Strength: 16.8 KV⁄mm
• Dispensing Method: Cartridge
• Elongation: 435%
• Hardness: 24 (Shore A)
• Primary Type: Adhesive
• Special Features: High Strength, Non-Corrosive
• Specific Gravity: 1.04
• Standards: UL Recognized
• Temperature Range: -60 to +205 °C
• Temperature, Rating: -60 to +204 °C
• Tensile Strength: 1.86 MPa
• Thermal Conductivity: 0.06 W⁄m.°K
• Time, Cure: 12 hr
• Time, Setting: 15 min.
• Viscosity: 360 g⁄Minute
• Volume Resistivity: 2 x 10^15 Ohm.cm
• Weight: 10 Oz.
• Main Industry: Electronics
• For Use With/related Products: Non Corrosive
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

NOTE TO PHYSICIAN
5. FIRE-FIGHTING MEASURES
FLASH POINT:
METHOD:
IGNITION TEMPERATURE:
FLAMMABLE LIMITS IN AIR - LOWER (%):
FLAMMABLE LIMITS IN AIR - UPPER (%):
SENSITIVITY TO MECHANICAL IMPACT:
SENSITIVITY TO STATIC DISCHARGE
EXTINGUISHING MEDIA
SPECIAL FIRE FIGHTING PROCEDURES
6. ACCIDENTAL RELEASE MEASURES
ACTION TO BE TAKEN IF MATERIAL IS RELEASED OR SPILLED
7. HANDLING AND STORAGE
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORAGE
RTV5818 12C-Crtrg (0.738LBS-0.335KG)
Silicone Rubber Sealant
Treatment is symptomatic and supportive.
Sensitivity to static discharge is not expected.
All standard extinguishing agents are suitable.
Firefighters must wear NIOSH/MSHA approved positive pressure self-contained breathing
apparatus with full face mask and full protective clothing.
Wipe, scrape or soak up in an inert material and put in a container for disposal. Wash walking
surfaces with detergent and water to reduce slipping hazard. Wear proper protective equipment as
specified in the protective equipment section. Increase area ventilation.
Product releases methanol during application and curing. Product releases ammonia during
application and curing. Use mechanical ventilation to stay below TLV of 25 ppm ammonia. Avoid
contact with skin and eyes. Use only in well-ventilated areas. Remove contact lenses before using
sealant. Do not handle lenses until all sealant has been cleaned from the fingertips, nails and cuticles.
Residual sealant may remain on fingers for several days and transfer to lenses and cause severe eye
irritation. Keep away from children.
Page 3/8
ca. 110 °C; 230 °F
closed cup
No data available
Not applicable
Not applicable
No
Material Safety Data Sheet
Version: 1.5
03/28/2008