6000-210023 Storm Interface, 6000-210023 Datasheet - Page 10

• Manufacturer Part Number: 6000-210023
• Description: KEYPAD MATRIX OUTPUT 6000 SERIES
• Manufacturer: Storm Interface
• Series: 6000r

Specifications of 6000-210023

• Switch Type: Conductive Rubber
• Number Of Keys: 16
• Matrix (columns X Rows): 4 x 4
• Output Type: Matrix
• Key Type: Polymer
• Legend: Calculator Format
• Interchangeable Legends: No
• Illumination: Non-Illuminated
• Seal Rating: IP65
• Vandal Resistant (20j Bs En 60068-2-75: 1997)
• Overall Dimensions: 124.0 mm × 118.5 mm × 17.5 mm
• Front Plate: Brushed Stainless Steel
• Keys: Super High Impact Polymer
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 6000-210021; 6000-210022; 6000-210023; MGR1620

Section 5. Fitting Encryption Device (PCB) to “Encyption Ready” Keypad
“Encryption Ready” Keypads are supplied with a separate kit comprising a pod housing (base and lid), fixings, and the
elastomeric connector. The customer supplies the encryption device(pcb) and cable. Assembly stages are as follows :-
1.
2.
3.
4.
5.
6.
This document is provided for use and guidance of engineering personnel engaged in the installation or application of STORM data entry products manufactured by Keymat Technology Ltd.
Please be advised that all information, data, and illustrations contained within this document remain the exclusive property of Keymat Technology Ltd. and are provided for the express and
exclusive use as described above. This document is not supported by Keymat Technology’s engineering change note, revision or reissue system. Data contained within this document is subject
to periodic revision, reissue or withdrawal. Whilst every effort is made to ensure the information, data and illustrations are correct at the time of publication, Keymat Technology Ltd. are not
responsible for any errors or omissions contained within this document.
1.1
Secure nuts first
(2 positions)
PCB Retaining
Clips
(3 positions)
Fit pod base assembly over the studs and secure with 2-off M3 nyloc nuts -Torque setting 70Ncm then fit 4-off
M3 x 10mm plastite screws - Torque setting: 70 Ncm.
Place Zebra Strip into pod base.
Fit (customer supplied) encoder assembly to pod base using the Jig to snap it into place. Take care not to bend
the pcb retaining clips.
Fit (customer supplied) cable and test.
If specified, fit 4 off anti-tamper boot to the pod lid.
Clip pod lid onto the base.
6000 Series Application/Engineering Manual Version 1.01 Feb 2004 Page 10 of 16
Application / Engineering Manual
6000 Series keypad for public environments
1.2
Then fit screws
(4 positions)