A22-H1 Omron, A22-H1 Datasheet - Page 202

• Manufacturer Part Number: A22-H1
• Description: LAMP A22 SER 120VAC INCANDESCENT
• Manufacturer: Omron
• Type: Incandescent Lamp, 10 mm Diameterr
• Series: A22Er

Specifications of A22-H1

• Accessory Type: Incandescent Lamp Replacement
• Illumination: Illuminated
• Height: 28 mm
• Mounting Style: Snap In
• Termination Style: Socket
• For Use With/related Products: A22 Series
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With: A22E Series
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: A22H1; Z1580

Installing the Switch Blocks
Hook the small protrusion on the Mounting Latch into the groove on
the other side of the lever, then push up the Switch Block in the direc-
tion indicated by the arrow in the figure below.
Removing the Switch Blocks
Insert a screwdriver between the Mounting Latch and the Switch
Block, then push down the screwdriver in the direction indicated by
the arrow in the following figure.
200
Installing/Removing the Switch
Blocks
Mounting
Latch
Flat-head
screwdriver
Phillips
screwdriver
Use either of the following screwdrivers.
3 to 6 mm dia.
3 to 6 mm
Switch Block
Screwdriver
Protrusion
Lever
Wiring Round Crimp Terminals
Loosen the terminal screw from the Switch Unit until it completely
comes off the groove, insert a screwdriver as shown in the following
figure, then push up the washer in the direction indicated by the
arrow to temporarily secure it. Now, a round crimp terminal can be
connected. After inserting the terminal, tighten the screws to com-
plete wiring.
Wiring
Washer
Screw
Screwdriver