MC13211 Freescale Semiconductor, MC13211 Datasheet - Page 13

• Manufacturer Part Number: MC13211
• Description: IC TXRX RF 2.4GHZ FLSH 16K 71LGA
• Manufacturer: Freescale Semiconductor
• Series: MC1321xr

Specifications of MC13211

• Frequency: 2.4GHz
• Data Rate - Maximum: 250kbps
• Modulation Or Protocol: 802.15.4 Zigbee
• Applications: General Purpose
• Power - Output: 3dBm
• Sensitivity: -92dBm
• Voltage - Supply: 1.8 V ~ 3.6 V
• Current - Receiving: 42mA
• Current - Transmitting: 35mA
• Data Interface: PCB, Surface Mount
• Memory Size: 16kB Flash, 1kB RAM
• Antenna Connector: PCB, Surface Mount
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 71-LGA
• Mounting Style: SMD/SMT
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

2.2
The MCU provides control for the 802.15.4 modem. The required interconnects between the devices are
routed onboard the SiP. In addition, the signals are brought out to external pads primarily for use as test
points. These signals can be useful when writing and debugging software.
Freescale Semiconductor
1
2
Pin #
During low power modes, input must remain driven by MCU.
By default MISO is tri-stated when CE is negated. For low power operation, miso_hiz_en (Bit 11, Register 07) should be set
to zero so that MISO is driven low when CE is negated.
43
44
46
PTE5/SPSCK1
PTE4/MOSI1
PTE3/MISO1
Internal Functional Interconnects
MCU Signal
PTE2/SS1
PTE6
PTE7
PTD0
PTD1
PTD3
IRQ
To use the MCU and modem signals as described in
to be programmed appropriately for the stated function.
Modem Signal
RXTXEN
SPICLK
M_RST
GPIO2
GPIO1
M_IRQ
MOSI
MISO
ATTN
CE
1
Table 3. Internal Functional Interconnects
1
2
1
1
MC13211/212/213 Technical Data, Rev. 1.8
Modem GPIO2 output acts as “CRC Valid” status indicator for Stream Data
Mode to MCU.
Modem GPIO1 output acts as “Out of Idle” status indicator for Stream Data
Mode to MCU.
MCU Port D Bit 0 drives the attention (ATTN) input of the modem to wake
modem from Hibernate or Doze Mode.
MCU SPI master SPI clock output drives modem SPICLK slave clock input.
MCU SPI master MOSI output drives modem slave MOSI input
Modem SPI slave MISO output drives MCU master MISO input
MCU SPI master SS output drives modem slave CE input
Modem interrupt request M_IRQ output drives MCU IRQ input
MCU Port D Bit 1 drives the RXTXEN input to the modem to enable TX or RX
or CCA operations.
MCU Port D Bit 3 drives the reset M_RST input to the modem.
NOTE
Table
Description
3, the MCU needs
13