F2M03GX-S04 Free2Move, F2M03GX-S04 Datasheet - Page 23

• Manufacturer Part Number: F2M03GX-S04
• Description: MOD BLUETOOTH V2.0+EDR USB EXT.
• Manufacturer: Free2Move

Specifications of F2M03GX-S04

• Frequency: 2.4GHz
• Data Rate - Maximum: 3Mbps
• Modulation Or Protocol: Bluetooth v2.0+EDR, Class 1, 2 & 3
• Applications: Bluetooth v2.0
• Power - Output: -8dBm ~ 18dBm
• Sensitivity: -92dBm
• Voltage - Supply: 3.1 V ~ 3.6 V
• Current - Receiving: 38mA
• Current - Transmitting: 250mA
• Data Interface: PCB, Surface Mount
• Antenna Connector: U.FL
• Operating Temperature: -40°C ~ 85°C
• Package / Case: Module
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Memory Size: -
• Other names: 647-1012-2

Rev: c
Extended range Bluetooth™ Module - F2M03GX /GXA
Datasheet
6.2.6 Suspend Current
USB devices that run off VBUS must be able to enter a suspended state, whereby they consume less that
0.5mA from VBUS. The voltage regulator circuit itself should draw only a small quiescent current (typically
less than 100µA) to ensure adherence to the suspend-current requirement of the USB specification. This is
not normally a problem with modern regulators. The entire circuit must be able to enter the suspend mode.
6.2.7 Detach and Wake_Up Signalling
F2M03 can provide out-of-band signalling to a host controller by using the dedicated control lines called
USB_DETACH and USB_WAKE_UP. These are outside the USB specification (no wires exist for them
inside the USB cable), but can be useful when embedding F2M03 into a circuit where no external USB is
visible to the user. Both control lines are shared with PIO pins and can be assigned to any PIO pin by
firmware settings (contact Free2move)
USB_DETACH, is an input which, when asserted high, causes F2M03 to put USB- and USB+ in a high-
impedance state and turns off the pull-up resistor on USB+. This detaches the device from the bus and is
logically equivalent to unplugging the device. When USB_DETACH is taken low, F2M03 will connect back
to USB and await enumeration by the USB host.
USB_WAKE_UP, is an active high output (used only when USB_DETACH is active) to wake up the host
and allow USB communication to recommence. It replaces the function of the software USB WAKE_UP
message (which runs over the USB cable proper), and cannot be sent while F2M03 is effectively
disconnected from the bus.
USB_DETACH and USB_WAKE_UP Signal
6.2.8 USB Driver
A USB Bluetooth device driver is required to provide a software interface between F2M03 and Bluetooth
applications running on the host. Free2move don’t supply this driver.
© 2006 Free2move AB
Page 23(47)