CB-OBS411I-04-A ConnectBlue, CB-OBS411I-04-A Datasheet - Page 22
![BLUETOOTH V2.1+EDR MODULE 4DBM](/photos/14/21/142110/cb-obs411i-04-a_sml.jpg)
CB-OBS411I-04-A
Manufacturer Part Number
CB-OBS411I-04-A
Description
BLUETOOTH V2.1+EDR MODULE 4DBM
Manufacturer
ConnectBlue
Specifications of CB-OBS411I-04-A
Frequency
2.4GHz
Data Rate - Maximum
115.2kbps
Modulation Or Protocol
Bluetooth v2.1+EDR, Class 2 & 3
Applications
General Purpose
Power - Output
4dBm
Sensitivity
-84dBm
Voltage - Supply
3 V ~ 6 V
Current - Receiving
15.5mA
Current - Transmitting
25.1mA
Data Interface
Solder Pads, 2 x 20mm, 1 mm pitch
Antenna Connector
On-Board, Trace
Operating Temperature
-30°C ~ 85°C
Package / Case
Module
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Memory Size
-
Other names
809-1032
connectBlue
Copyright © 2010 connectBlue AB
Figure 10: Host PCB layout [mm] for double row connector.
A press-fit nut is pressed into the PCB from the bottom side with a special press tool. M2 sized press-fit nuts are suitable for the modules
(see Figure 9 and Figure 10) and are manufactured by PEM Fastening Systems (
Be careful with the distance between the nuts regarding alignment, see the
Figure 11: KFS2-M2 press-fit nut.
Spacer-pipes are recommended to use between the PCBs when press-fit nuts are used.
The host PCB footprint should not contain any traces or vias under the module except the pads interfacing the J6 pads to avoid contact
with traces/vias on the module. The host pads which are soldered to the J6 pads should reach 0.5-1.0mm under the PCB and some mm
outside the module. No other pads than the J6 should be soldered to the host PCB. See section
about the J6 pads.
We strongly recommend the modules not being soldered more than 1 time after shipping from connectBlue and that the modules are
mounted just before the host product is being soldered the last time. Although, connectBlue devices will withstand up to two reflows to an
absolute maximum temperature of 250°C.
6.3 Using Press-Fit Nuts for Mounting the Module
6.4 Using the J6 PCB solder pads
6.4.1 Host Board
6.4.2 Mounting process
The PCB in our modules is made of FR4-type with Chemical Gold Pads.
Mounting Holes
www.pemnet.com
section.
J2, J3 and J6 Connectors
), part no KFS2-M2 (see Figure 11).
Page 22 of 42
for more info