ATMEGA256RZBV-8AU Atmel, ATMEGA256RZBV-8AU Datasheet - Page 92

• Manufacturer Part Number: ATMEGA256RZBV-8AU
• Description: MCU ATMEGA2560/AT86RF230 100TQFP
• Manufacturer: Atmel
• Series: ATMEGAr

Specifications of ATMEGA256RZBV-8AU

• Frequency: 2.4GHz
• Modulation Or Protocol: 802.15.4 Zigbee
• Applications: ISM, ZigBee™
• Power - Output: 3dBm
• Sensitivity: -101dBm
• Voltage - Supply: 1.8 V ~ 3.6 V
• Current - Receiving: 15.5mA
• Current - Transmitting: 16.5mA
• Data Interface: PCB, Surface Mount
• Memory Size: 256kB Flash, 4kB EEPROM, 8kB RAM
• Antenna Connector: PCB, Surface Mount
• Package / Case: 100-TQFP
• Wireless Frequency: 2.4 GHz
• Interface Type: JTAG, SPI
• Output Power: 3 dBm
• Operating Temperature Range: - 55 C to + 125 C
• For Use With: ATAVRISP2 - PROGRAMMER AVR IN SYSTEMATJTAGICE2 - AVR ON-CHIP D-BUG SYSTEM
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Operating Temperature: -
• Data Rate - Maximum: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: ATmega256

Data Sheet Revision History
Rev. 5131E-ZIGB-02/04/09
Rev. 5131D-ZIGB-12/03/07
Rev. 5131C-ZIGB-05/22/07
Rev. 5131A-ZIGB-06/14/06
92
AT86RF230
1. Removed PRELIMINARY statement
2. Updated parameter 11.4.4
3. Minor editorial changes
The AT86RF230 data sheet was fully revised and modifications of silicon revision
AT86RF230 Rev. B were incorporated. A migration note of silicon revision A to revision
B is available on www.atmel.com.
The most important modifications are:
4. Device version number in register 0x1D (VERSION_NUM) changed to 2 (section 6.3)
5. SPI Interface: MISO pin is updated on falling edge at pin SCLK (section 6.1)
6. Extended Operating Mode state diagram: State changes towards RX_AACK_ON
7. Enhanced return code of TX_ARET transaction in register bits TRAC_STATUS of
8. FCS check of received frames in Basic Operating Mode (section 8.2)
9. Support of pending data indication in Extended Operating Mode (sections 7.2.3.1,
10. Update package drawing (section 16)
1. Major revise of sections 1 to 10
2. Added “Appendix A - Continuous Transmission Test Mode”
3. Added “Appendix B - Errata”
1. Initial release
and TX_ARET_ON (Figure 7-5)
register 0x02 (section 7.2.3.2)
7.2.3.2)
5131E-MCU Wireless-02/09