E-TDA7512FTR STMicroelectronics, E-TDA7512FTR Datasheet - Page 18

• Manufacturer Part Number: E-TDA7512FTR
• Description: IC TUNER AM/FM CAR RADIO 64-LQFP
• Manufacturer: STMicroelectronics

Specifications of E-TDA7512FTR

• Modulation Or Protocol: AM, FM
• Applications: Automotive Audio
• Current - Receiving: 70mA
• Data Interface: PCB, Surface Mount
• Antenna Connector: PCB, Surface Mount
• Voltage - Supply: 7.5 V ~ 10 V
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 64-LQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Features: -
• Frequency: -
• Sensitivity: -
• Memory Size: -
• Data Rate - Maximum: -

Functional description
4.3.3
4.3.4
4.3.5
4.3.6
4.4
18/45
charge current is fixed and the discharge current is controlled by I
produces digital signals (ac, ac+) in an additional comparator4. The adjacent channel
information is available as analog output signal after rectifier and +8 dB output buffer.
Multipath detector
The input of the multipath detector is AC coupled from internal unweighted fieldstrength. A
programmable bandpass (MPF) and amplifier (MPG) as well as rectifier determines the
influences. This voltage is compared with an adjustable comparator2 thresholds (MPTH).
The output signal of this comparator 2 is used for the "Milano" effect. In this case the
adjacent channel detection is switched off. The "Milano" effect is selectable by I
(MPOFF). The multipath information is available as analog output signal after rectifier and
+8 dB output buffer.
450 kHz IF narrow bandpass filter (ISS filter)
The device gets an additional second IF narrow bandpass filter for suppression of noise and
adjacent channel signal influences. This narrow filter has three switchable bandwidthes,
narrow range of 80 kHz, mid range of 120 kHz and 30 kHz for weather band information.
Without ISS filter the IF bandwidth (wide range) is defined only by ceramic filter chain. The
filter is switched in after mixer 2 before 450 kHz limiter stage. The centre frequency is
matching to the demodulator center frequency.
Deviation detector
In order to avoid distortion in audio output signal the narrow ISS filter is switched OFF for
present overdeviation. Hence the demodulator output signal is detected.
A lowpass filtering and peak rectifier generates a signal that is defined by software
controlled current (TDEV) in an external capacitance. This value is compared with a
programmable comparator3 thresholds (DWTH, DTH) and generates two digital signals
(dev, dev+). For weak signal condition deviation threshold is proportinal to FSU.
ISS switch logic
All digital signals coming from adjacent channel detector, deviation detector and softmute
are acting via switching matrix on ISS filter switch. The IF bandpass switch mode is
controlled by software (ISSON, ISS30, ISS80, CTLOFF).
The switch ON of the IF bandpass is also available by external manipulation of the voltage at
PIN15.
Two application modes are available (APPM). The conditions are described in table 34.
Soft Mute control
The external fieldstrength signal at PIN 35 is the reference for mute control. The startpoint
and mute depth are programmable (SMTH, SMD) in a wide range. The time constant is
defined by external capacitance. Additional adjacent channel mute function is supported.
A highpass filter with -3 dB threshold frequency of 100 kHz, amplifier and peak rectifier
generates an adjacent noise signal from MPX output with the same time constant for
Doc ID 12668 Rev 2
2
C Bus. This level
2
C bus
TDA7512F