1014-TAB1D434 Silicon Laboratories Inc, 1014-TAB1D434 Datasheet - Page 20
![BOARD EVALUATION FOR SI1014](/photos/28/98/289802/si10xx-txb_sml.jpg)
1014-TAB1D434
Manufacturer Part Number
1014-TAB1D434
Description
BOARD EVALUATION FOR SI1014
Manufacturer
Silicon Laboratories Inc
Type
Transceiver, ISMr
Specifications of 1014-TAB1D434
Mfg Application Notes
SI1000 Code Examples AppNote
Frequency
434MHz
Supply Voltage (min)
0.9 V
Product
RF Modules
Maximum Frequency
915 MHz
Output Power
13 dBm
Antenna
SMA
Supply Voltage (max)
3.6 V
For Use With/related Products
Si101x
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Lead Free Status / RoHS Status
Lead free / RoHS Compliant, Lead free / RoHS Compliant
Other names
336-1883
Si10xx-DK
10.10. IREF Connector (J7)
The Si1000 Motherboard also features a current-to-voltage 1 k load resistor that may be connected to the current
reference (IREF0) output that can be enabled on port pin (P0.7). Install a shorting block on J7 to connect port pin
P0.7 of the target device to the load resistor. If enabled by software, the IREF0 signal is then routed to the J2[8]
and H1[2] connectors.
10.11. VREF and AGND Connector (J13, J14)
The Si1000 Motherboard also features 4.7 µF capacitor in parallel with a 0.1 µF that can be connected to P0.0/
VREF when using the Precision Voltage Reference. The capacitors are connected to P0.0/VREF when a shorting
block is installed on J13. Using the Precision Voltage Reference is optional since Si10xx devices have an on-chip
High-Speed Voltage Reference.
The shorting block J14 allows P0.1/AGND to be connected to ground. This provides a noise-free ground reference
to the analog-to-digital Converter. The use of this dedicated analog ground is optional.
10.12. C2 Pin Sharing
On the Si10xx, the debug pins C2CK and C2D are shared with the pins RST and P2.7, respectively. The target
board includes the resistors necessary to enable pin sharing which allow the RST and P2.7 pins to be used
normally while simultaneously debugging the device. See Application Note “AN124: Pin Sharing Techniques for the
C2 Interface” at
www.silabs.com
for more information regarding pin sharing.
20
Rev. 0.1