GS-BT2416C1DBAT1 STMicroelectronics, GS-BT2416C1DBAT1 Datasheet - Page 20
GS-BT2416C1DBAT1
Manufacturer Part Number
GS-BT2416C1DBAT1
Description
BOARD DEMO CLASS 1 W/SERIAL PORT
Manufacturer
STMicroelectronics
Type
Bluetoothr
Specifications of GS-BT2416C1DBAT1
Contents
Board
Processor Series
STLC2500
Wireless Frequency
2.4 GHz to 2.5 GHz
Interface Type
RS-232, USB
For Use With/related Products
GS-BT2416C1.A
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Other names
497-5793
AT command
A.3
20/38
Moreover it is possible to store a startup commands sequence directly into flash memory.
The sequence can be long up to 512bytes. If a macro sequence is present, in startup phase,
some OK events are generated, one for every command of the sequence, before the
+READY event.
This behavior can be avoided setting a AT+ECHO = OFF command starting the macro
(avoiding the +READY too). The sequence execution is stoppable changing the state of
GPIO3 in startup phase.
Interfaces
The module must be controlled by an external MCU using the UART and 2 GPIOs.
●
When these settings are changed by the AT+UARTSETUP command, they are stored in the
flash memory to be reloaded when the module is powered up the next time.
●
●
If GPIO3 is set to low, the module switches its mode of operation to COMMAND MODE.
UART: used to control the module with AT commands (COMMAND MODE), or
send/receive serial data to be transmitted over the SPP Bluetooth
The first time that the module is powered up, the default UART settings are as following
(saved in flash memory):
GPIO1: configured as output. GPIO1 is high when an SPP Bluetooth
device is present. GPIO1 is low when no Bluetooth
GPIO3: configured as input. If GPIO3 is set to high the module switches its mode of
operation to DATA MODE.
Baud rate: (bps) 9600
Data bits: 8
Parity: None
Stop bits: 1
Flow control: None
®
link is present.
®
GS-BT2416C1.AT1
link (DATA MODE).
®
link to a remote