AT86RF211-DK868107 Atmel, AT86RF211-DK868107 Datasheet - Page 22

• Manufacturer Part Number: AT86RF211-DK868107
• Description: KIT DEV FOR AT86RF211/868MHZ
• Manufacturer: Atmel
• Series: Smart RFr
• Type: Transceiverr

Specifications of AT86RF211-DK868107

• Mfg Application Notes: SmartRF Series Application Note
• Contents: 868MHz Frequency, 2 AVR Boards, Embedded Demos, In-System Programming possibility
• For Use With/related Products: AT86RF211 @ 866MHz
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: AT86RF211DK868107

5307C–WIRE–04/04
Using this Kit for (RF) Evaluation
4.2.2
4-8
DEMO (Action Menu) 1. When you click on EXECUTE, the defined configuration is sent into AT86RF211
3. To save a given configuration, click on SAVE and enter a name xxxx.cfg.
4. To load a given configuration click on LOAD and enter the name xxxx.cfg of a
5. Click on INIT to go back to the default RESET configuration of AT86RF211.
Other possibilities for frequency management:
Inverted Output Data option changes the polarity of the output data.
RX general parameters:
View of register values (corresponding to the chosen configuration):
– The 4 frequency registers can be computed one after the other: click on
– Keep freq option: “freezes” frequencies: they will no longer be changed inside
– Range (%): sets the level of output power, from 100% to 9% of maximum
– RSSI threshold (dBm): data reception output is inhibited if RSSI is lower than
– Hysteresis ± (dB): hysteresis associated to the previous level.
– When Clock Recovery is enabled, the data rate and data rate tolerance
– View CTRL & STATUS REG: image of CTRL1, CTRL2 and STAT registers.
– View FREQ & DTR REG: image of the 4 frequencies and DTR registers.
previously saved configuration.
(if not already done, the frequency codes are automatically computed). The link
with AT86RF211 is established and maintained, and the state of AT86RF211 is
continuously displayed:
– Battery level, state of the PLL (locked/unlocked) and RSSI level in Rx mode.
– Battery level and state of the PLL (locked/unlocked) in Tx mode.
Manual freq., fill in the frequencies and click on COMPUTE.
the AT86RF211 when going from the SETUP to DEMO.
power set by R
this level.
appear and must be set to the desired value (rounded to the nearest value the
transceiver is able to generate).
>280 kHz => bandwidth less than 600 kHz. The accuracy of the
synthesizer is typ. 1 kHz with a maximum of approximately 3 kHz.
POWER
.
AT86RF211 Development Kit User Guide