DK-DEV-4CGX150N Altera, DK-DEV-4CGX150N Datasheet - Page 23

• Manufacturer Part Number: DK-DEV-4CGX150N
• Description: KIT STARTER CYCLONE IV GX
• Manufacturer: Altera
• Series: CYCLONE® IV GXr
• Type: FPGAr

Specifications of DK-DEV-4CGX150N

• Contents: Board, Cable, Documentation, Power Supply
• For Use With/related Products: Cyclone IV GX
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 544-2713

Chapter 6: Board Test System
Using the Board Test System
© March 2010 Altera Corporation
■
■
■
■
■
■
■
MAX II Registers
The MAX II registers control allow you to view and change the current MAX II
register values as described in
take effect immediately. For example, writing a 0 to SRST resets the board.
Table 6–2. MAX II Registers
System Reset
(SRST)
Page Select Register
(PSR)
Page Select Override
(PSO)
Page Select Switch
(PSS)
Name—Indicates the official name of the board, given by the Board Test System.
Part number—Indicates the part number of the board.
Serial number—Indicates the serial number of the board.
Factory test version—Indicates the version of the Board Test System currently
running on the board.
Factory test date—Indicates the release date of the Board Test System currently
running on the board.
MAX II version—Indicates the version of MAX II code currently running on the
board. The MAX II code resides in the <install
dir>\kits\cycloneIVGX_4cgx15_starter\examples directory. Newer revisions of
this code might be available on the
the Altera website.
MAC address—Indicates the MAC address of the board.
Register Name
Write only
Read / Write
Read / Write
Read only
Read/Write
Capability
Table
Set to 0 to initiate an FPGA reconfiguration.
Determines which of the pages of flash memory to use for
FPGA reconfiguration. The flash memory ships with pages 0
and 1 preconfigured.
When set to 0, the value in PSR determines the page of
flash memory to use for FPGA reconfiguration. When set to
1, the value in PSS determines the page of flash memory to
use for FPGA reconfiguration.
Holds the current value of the iluminated PGM LEDs (D3-
D4) based on the following encoding:
■
■
■
6–2. Changes to the register values with the GUI
0 = PGM 0 LED (D4) on and PGM 1 LED (D3) on, and
corresponds to the flash memory page for the factory
hardware design
1 = PGM 0 LED (D4) on and PGM 1 LED (D3) off, and
corresponds to the flash memory page for the user
hardware 1 design
2 = PGM 0 LED (D4) off and PGM 1 LED (D3) on, and
corresponds to the flash memory page for the user
hardware 2 design
Cyclone IV GX Transceiver Starter Kit
Cyclone IV GX Transceiver Starter Kit User Guide
Description
page of
6–5