GLK12232-25-SM-R14 Matrix Orbital, GLK12232-25-SM-R14 Datasheet - Page 20
![LCD GRAPHIC DISPL 122X32 WHT/BLU](/photos/13/95/139512/glk12232-25-sm_back_sml.jpg)
GLK12232-25-SM-R14
Manufacturer Part Number
GLK12232-25-SM-R14
Description
LCD GRAPHIC DISPL 122X32 WHT/BLU
Manufacturer
Matrix Orbital
Datasheet
1.GLK12232-25-SM-WB.pdf
(42 pages)
Specifications of GLK12232-25-SM-R14
Display Type
LCD - Monochrome
Display Mode
Transmissive
Viewing Area
60.20mm L x 18.00mm W
Backlight
LED - White
Dot Size
0.40mm W x 0.40mm H
Dot Pitch
0.44mm x 0.44mm
Dot Pixels
122 x 32
Interface
I²C, RS232, TTL
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Other names
635-1000
GLK12232-25-SM
GLK12232-25-SM
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
GLK12232-25-SM-R14
Manufacturer:
Matrix Orbital
Quantity:
135
5.3 Flow Control
placement. Flow control is enabled or disabled by two commands. If flow control is enabled, the display
will return an “almost full” message (0xFE) to the micro-controller when its internal buffer fills to a defined
level, and an “almost empty" message (0xFF) when the buffer contents drop to a defined level.
5.3.1 Enter Flow Control Mode (254 58 [full][empty])
This command enables flow control. When the buffer fills so that only [full] bytes are available the display
will return an "almost full" message (0xFE) to the micro-controller. When the buffer empties so that only
[empty] bytes remain the display will return an "almost empty" message (0xFF) to the micro-controller.
space once more drops below the [full] level.
which would over-run the buffer. While in ’flow control mode’ the unit will return 0xFE when the buffer is
almost full even though it may have already thrown rejected data away. The buffer size for the display is 96
bytes.
considered very carefully. This is a critical aspect of using this command to it’s full potential. When using a
host system or PC which contains a FIFO, the user should set the value of equal to or greater than the size of
the FIFO. The reason for this is that the FIFO may be full when the host system receives 0xFE. In the case
of 16550 UART the size at its maximum is 16, therefore the value of should be set to 16 or greater.
5.3.2 Exit Flow Control Mode (254 59)
6 Keypad Interface
Matrix Orbital
The display has built in flow control which is very useful during direct bitmap display and multiple pixel
The display will return the "almost full" message for every byte sent to the display until the used buffer
Whether the user is in ’flow control mode’ or not, the module will ignore display or command bytes
When using this command in an application, selection of the value for the buffer almost full should be
This command turns off flow control. Bytes may overflow the buffer without warning.
This chapter describes the keypad interface and associated commands in detail.
NOTE Flow control applies only to the RS-232 interface. It is not available for I
NOTE
recommended for use with direct screen write and multiple pixel placements.
This mode must not be used during loading of fonts and bitmaps. It is highly
GLK12232-25-SM
2
C.
16