STM6904SFEDS6F STMicroelectronics, STM6904SFEDS6F Datasheet - Page 7

• Manufacturer Part Number: STM6904SFEDS6F
• Description: IC SUPERVISOR ULV QUAD 8-MSOP
• Manufacturer: STMicroelectronics
• Type: Multi-Voltage Supervisorr

Specifications of STM6904SFEDS6F

• Number Of Voltages Monitored: 4
• Output: Open Drain or Open Collector
• Reset: Active Low
• Reset Timeout: 140 ms Minimum
• Voltage - Threshold: 1.05V, 2.955V, Adj, Adj
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 8-MSOP, Micro8™, 8-uMAX, 8-uSOP,
• Monitored Voltage: 2.955 V, 1.05 V
• Undervoltage Threshold: 2.925 V, 1.04 V
• Manual Reset: Resettable
• Watchdog: No Watchdog
• Supply Voltage (max): 5.5 V
• Supply Voltage (min): 0.8 V
• Supply Current (typ): 14 uA
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Minimum Operating Temperature: - 40 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 497-8722-2

2
2.1
2.2
2.3
2.4
2.5
2.6
Pin descriptions
Push-button reset input (MR)
When MR goes low the RST output is driven low, RST remains low as long as MR is low and
for t
resistor to V
outputs, or connected to V
V
Connect a normally open momentary switch from MR to V
not required. (If MR is driven from long cables or if the device is used in noisy environments,
connecting a 0.1 uF capacitor from MR to V
V
The V
selectable, factory programmed) reset thresholds include 3.078 V to 2.866 V.
V2IN second fixed voltage monitoring input
The V2IN input is the second fixed-voltage input for reset threshold monitoring. Available
fixed (customer-selectable, factory programmed) reset thresholds include 2.333 V to
1.050 V.
V
This pin is the ground pin for the power supply.
V3IN and V4IN
The V3IN and V4IN are high impedance inputs. RST is driven low when the voltage (V
at the pin falls below 600 mV (internal reference voltage at their respective comparators).
The monitored voltage reset threshold is set with an external resistor-divider network.
RST active-low, open drain reset output
The reset output (RST) pin is driven low and stays low whenever V
V4IN falls below its factory-trimmed or adjustable reset threshold or when MR goes to logic
low. It remains low for t
thresholds and MR goes from low to high. Connect an external pull-up resistor to V
10k ohms pull-up resistor should be sufficient for most applications.
CC
CC
SS
REC
.
CC
primary supply voltage monitoring input
after MR returns to high. The active-low input has an internal 10k ohm pull-up
pin is also the input for the primary reset threshold monitor. Fixed (customer-
CC
. It can be driven from a TTL or CMOS logic line, or with open drain/collector
rec
after all supply voltages being monitored rise above their reset
SS
through a switch. If unused, leave this pin open or connect it to
SS
provides additional noise immunity).
SS
; external debounce circuitry is
CC
or V2IN, or V3IN, or
CC
TRIP
. A
7/21
)