AD8330ACP-REEL7 Analog Devices Inc, AD8330ACP-REEL7 Datasheet - Page 29

• Manufacturer Part Number: AD8330ACP-REEL7
• Description: IC AMP VGA 150MHZ LN LP 16LFCSP
• Manufacturer: Analog Devices Inc

Specifications of AD8330ACP-REEL7

• Rohs Status: RoHS non-compliant
• Amplifier Type: Variable Gain
• Number Of Circuits: 1
• Output Type: Differential, Rail-to-Rail
• Slew Rate: 1500 V/µs
• -3db Bandwidth: 150MHz
• Current - Input Bias: 100nA
• Current - Supply: 20mA
• Voltage - Supply, Single/dual (±): 2.7 V ~ 6 V
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 16-LFCSP
• For Use With: AD8330-EVALZ - BOARD EVAL FOR AD8330
• Current - Output / Channel: -
• Gain Bandwidth Product: -
• Voltage - Input Offset: -

OPTIONS
Table 6 lists the jumpers on the board and their functions.
Table 6. Functions of Jumpers
Name
FLTR
OFST
UP
DOWN
Connects a high-pass filter to the offset control loop
pin. This jumper is normally not installed.
Disables the offset correction loop. This jumper is
installed for dc or low frequency operation.
Mode up. Install for ascending gain with increasing
VDBS gain control voltage.
Mode down. Install for descending gain with
increasing VDBS gain control voltage.
Function
POWER SUPPLY
PRECISION VOLTAGE REFERENCES
+5V
(FOR VDBS, VMAG)
GND
SIGNAL
INPUT
Figure 71. Typical Connections
NETWORK
ANALYZER
Rev. E | Page 29 of 32
MEASUREMENT SETUP
The basic board connections for a typical measurement are
shown in Figure 71. To minimize circuit-loading effects, a low
capacitance FET probe is recommended for observing input or
output waveforms. Two-pin headers, IN_TEST and OUT_TEST,
are provided for this purpose. The SMA connectors OUT_HI
and OUT_LO can also be used, but the user may need to
account for load capacitance effects.
AD8330-EVALZ BOARD DESIGN
The AD8330-EVALZ is a 4-layer design for maximum ground-
plane area. The evaluation board side silkscreen and wiring
patterns are shown in Figure 72 through Figure 77.
POWER SUPPLY
DIFFERENTIAL
PROBE
PROBE
AD8330