TS321AILT STMicroelectronics, TS321AILT Datasheet - Page 3

• Manufacturer Part Number: TS321AILT
• Description: IC OP AMP SINGLE LOW PWR SOT23-5
• Manufacturer: STMicroelectronics

Specifications of TS321AILT

• Amplifier Type: General Purpose
• Number Of Circuits: 1
• Slew Rate: 0.4 V/µs
• Gain Bandwidth Product: 800kHz
• Current - Input Bias: 20nA
• Voltage - Input Offset: 500µV
• Current - Supply: 600µA
• Current - Output / Channel: 40mA
• Voltage - Supply, Single/dual (±): 3 V ~ 30 V, ±1.5 V ~ 15 V
• Operating Temperature: -40°C ~ 125°C
• Mounting Type: Surface Mount
• Package / Case: SOT-23-5, SC-74A, SOT-25
• Number Of Channels: 1
• Common Mode Rejection Ratio (min): 65 dB
• Input Offset Voltage: 2 mV
• Input Bias Current (max): 150 nA
• Operating Supply Voltage: 5 V, 9 V, 12 V, 15 V
• Supply Current: 0.8 mA
• Maximum Operating Temperature: + 125 C
• Minimum Operating Temperature: - 40 C
• Dual Supply Voltage: +/- 3 V, +/- 5 V, +/- 9 V, +/- 12 V
• Maximum Dual Supply Voltage: +/- 15 V
• Minimum Dual Supply Voltage: +/- 1.5 V
• Mounting Style: SMD/SMT
• Shutdown: No
• Supply Voltage (max): 30 V
• Supply Voltage (min): 3 V
• Technology: Bipolar
• Voltage Gain Db: 100 dB
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Output Type: -
• -3db Bandwidth: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 497-8093-2; TS321AILT

TS321
2
Table 1.
1. Short-circuits from the output to V
2. This input current only exists when the voltage at any of the input leads is driven negative. It is due to the collector-base
3. Short-circuits can cause excessive heating. Destructive dissipation can result from simultaneous short-circuits on all
4. Human body model: a 100 pF capacitor is charged to the specified voltage, then discharged through a 1.5 kΩ resistor
5. Machine model: a 200 pF capacitor is charged to the specified voltage, then discharged directly between two pins of the
6. Charged device model: all pins and the package are charged together to the specified voltage and then discharged directly
Symbol
approximately 40 mA independent of the magnitude of V
junction of the input PNP transistor becoming forward biased and thereby acting as input diodes clamps. In addition to this
diode action, there is also NPN parasitic action on the IC chip. This transistor action can cause the output voltages of the
Op-amps to go to the V
negative. This is not destructive and normal output is restored when the input voltage goes back above -0.3V.
amplifiers. All values are typical.
between two pins of the device. This is done for all couples of connected pin combinations while the other pins are floating.
device with no external series resistor (internal resistor < 5 Ω). This is done for all couples of connected pin combinations
while the other pins are floating.
to the ground through only one pin. This is done for all pins. The CDM value applies to SO-8 only.
V
ESD
R
R
T
V
CC
I
V
T
thja
thjc
stg
in
id
i
j
+
Absolute maximum ratings and operating conditions
Absolute maximum ratings
Supply voltage
Input voltage
Differential input voltage
Output short-circuit duration
Input current
Storage temperature range
Maximum junction temperature
Thermal resistance junction to ambient
Thermal resistance junction to case
HBM: human body model
MM: machine model
CDM: charged device model
SOT23-5
SO-8
SOT23-5
SO-8
SOT23-5
SO-8
CC
voltage level (or to ground for a large overdrive) for the time during which an input is driven
(2)
CC
(5)
can cause excessive heating if V
Parameter
(4)
(6)
(1)
Doc ID 6298 Rev 7
(3)
Absolute maximum ratings and operating conditions
CC
(3)
.
CC
> 15 V. The maximum output current is
-65 to +150
-0.3 to +32
±16 to 32
Infinite
Value
+150
1000
1500
+32
250
125
300
200
50
81
40
°C/W
°C/W
Unit
mA
°C
°C
V
V
V
V
3/15