MC68HC11E1CFN3 Freescale Semiconductor, MC68HC11E1CFN3 Datasheet - Page 260

• Manufacturer Part Number: MC68HC11E1CFN3
• Description: IC MCU 3MHZ 512 EEPROM 52-PLCC
• Manufacturer: Freescale Semiconductor
• Series: HC11r

Specifications of MC68HC11E1CFN3

• Core Processor: HC11
• Core Size: 8-Bit
• Speed: 3MHz
• Connectivity: SCI, SPI
• Peripherals: POR, WDT
• Number Of I /o: 38
• Program Memory Type: ROMless
• Eeprom Size: 512 x 8
• Ram Size: 512 x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 8x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 52-PLCC
• Data Bus Width: 8 bit
• Data Ram Size: 512 B
• Interface Type: SCI, SPI
• Maximum Clock Frequency: 3 MHz
• Number Of Programmable I/os: 22
• Number Of Timers: 16 bit
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Minimum Operating Temperature: - 40 C
• On-chip Adc: 8 bit
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Program Memory Size: -
• Lead Free Status / Rohs Status: Details

Engineering Bulletin
To Execute the Program
Step 1
Step 2
Step 3
260
Once you have obtained PCbug11, use this step-by-step procedure.
Apply power to the programmer board by moving the +5-volt switch to
the ON position.
From a DOS command line prompt, start PCbug11 this way:
PCbug11only supports COM ports 1 and 2.
PCbug11 defaults to base ten for its input parameters.
Change this to hexadecimal by typing
•
•
•
•
•
•
•
Freescale Semiconductor, Inc.
For More Information On This Product,
Before applying power to the programming board, connect the
M68HC711E9PGMR serial port P2 to one of your PC COM ports
with a standard 25 pin RS-232 cable. Do not use a null modem
cable or adapter which swaps the transmit and receive signals
between the connectors at each end of the cable.
Place your MC68HC811E2 part in the PLCC socket on your
board.
Insert the part upside down with the notched corner pointing
toward the red power LED.
Make sure both S1 and S2 switches are turned off.
Apply +5 volts to +5 volts and ground to GND on the programmer
board’s power connector, P1. Applying voltage to the V
not necessary.
C:\PCBUG11\> PCBUG11 –A PORT = 1
when the E9PGMR connected to COM1 or
C:\PCBUG11\> PCBUG11 –A PORT = 2
when the E9PGMR connected to COM2
CONTROL BASE HEX
Go to: www.freescale.com
MOTOROLA
PP
pin is
EB188