AT90S2313-4PI Atmel, AT90S2313-4PI Datasheet - Page 41

• Manufacturer Part Number: AT90S2313-4PI
• Description: IC MCU 2K 4MHZ UART LV IT 20DIP
• Manufacturer: Atmel
• Series: AVR® 90Sr

Specifications of AT90S2313-4PI

• Core Processor: AVR
• Core Size: 8-Bit
• Speed: 4MHz
• Connectivity: SPI, UART/USART
• Peripherals: Brown-out Detect/Reset, POR, PWM, WDT
• Number Of I /o: 15
• Program Memory Size: 2KB (1K x 16)
• Program Memory Type: FLASH
• Eeprom Size: 128 x 8
• Ram Size: 128 x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 6 V
• Oscillator Type: External
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 20-DIP (0.300", 7.62mm)
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Data Converters: -

Prevent EEPROM
Corruption
0839I–AVR–06/02
During periods of low V
age is too low for the CPU and the EEPROM to operate properly. These issues are the
same as for board-level systems using the EEPROM, and the same design solutions
should be applied.
An EEPROM data corruption can be caused by two situations when the voltage is too
low. First, a regular write sequence to the EEPROM requires a minimum voltage to
operate correctly. Secondly, the CPU itself can execute instructions incorrectly if the
supply voltage for executing instructions is too low.
EEPROM data corruption can easily be avoided by following these design recommen-
dations (one is sufficient):
1. Keep the AVR RESET active (low) during periods of insufficient power supply
2. Keep the AVR core in Power-down sleep mode during periods of low V
3. Store constants in Flash memory if the ability to change memory contents from
voltage. This is best done by an external low V
referred to as a Brown-out Detector (BOD). Please refer to the AVR 180 applica-
tion note for design considerations regarding Power-on Reset and low-voltage
detection.
will prevent the CPU from attempting to decode and execute instructions, effec-
tively protecting the EEPROM Registers from unintentional writes.
software is not required. Flash memory cannot be updated by the CPU and will
not be subject to corruption.
CC
, the EEPROM data can be corrupted because the supply volt-
CC
Reset Protection circuit, often
AT90S2313
CC
. This
41