SAK-XE164HN-16F80L AA Infineon Technologies, SAK-XE164HN-16F80L AA Datasheet - Page 73

• Manufacturer Part Number: SAK-XE164HN-16F80L AA
• Description: IC MCU 16BIT 128KB FLASH 100LQFP
• Manufacturer: Infineon Technologies
• Series: XE16xr

Specifications of SAK-XE164HN-16F80L AA

• Core Processor: C166SV2
• Core Size: 16-Bit
• Speed: 80MHz
• Connectivity: EBI/EMI, I²C, LIN, SPI, SSC, UART/USART, USI
• Peripherals: I²S, POR, PWM, WDT
• Number Of I /o: 75
• Program Memory Size: 128KB (128K x 8)
• Program Memory Type: FLASH
• Ram Size: 18K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 5.5 V
• Data Converters: A/D 16x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 125°C
• Package / Case: 100-LSQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

XE164FN, XE164GN, XE164HN, XE164KN
XE166 Family / Value Line
Electrical Parameters
4.3
DC Parameters
These parameters are static or average values that may be exceeded during switching
transitions (e.g. output current).
The XE164xN can operate within a wide supply voltage range from 3.0 V to 5.5 V.
However, during operation this supply voltage must remain within 10 percent of the
selected nominal supply voltage. It cannot vary across the full operating voltage range.
Because of the supply voltage restriction and because electrical behavior depends on
the supply voltage, the parameters are specified separately for the upper and the lower
voltage range.
During operation, the supply voltages may only change with a maximum speed of
dV/dt < 1 V/ms.
Leakage current is strongly dependent on the operating temperature and the voltage
level at the respective pin. The maximum values in the following tables apply under worst
case conditions, i.e. maximum temperature and an input level equal to the supply
voltage.
The value for the leakage current in an application can be determined by using the
respective leakage derating formula (see tables) with values from that application.
The pads of the XE164xN are designed to operate in various driver modes. The DC
parameter specifications refer to the pad current limits specified in
Section
4.7.4.
Data Sheet
73
V1.2, 2010-04