DSPIC30F2020-30I/MM Microchip Technology, DSPIC30F2020-30I/MM Datasheet - Page 7

• Manufacturer Part Number: DSPIC30F2020-30I/MM
• Description: IC DSPIC MCU/DSP 12K 28QFN
• Manufacturer: Microchip Technology
• Series: dsPIC™ 30Fr

Specifications of DSPIC30F2020-30I/MM

• Core Processor: dsPIC
• Core Size: 16-Bit
• Speed: 30 MIPs
• Connectivity: I²C, IrDA, LIN, SPI, UART/USART
• Peripherals: Brown-out Detect/Reset, POR, PWM, WDT
• Number Of I /o: 21
• Program Memory Size: 12KB (4K x 24)
• Program Memory Type: FLASH
• Ram Size: 512 x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 5.5 V
• Data Converters: A/D 8x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 28-QFN
• Core Frequency: 15MHz
• Core Supply Voltage: 3.3V
• Embedded Interface Type: I2C, SPI, UART
• No. Of I/o's: 21
• Flash Memory Size: 12KB
• Supply Voltage Range: 3V To 3.6V
• Package: 28QFN-S EP
• Device Core: dsPIC
• Family Name: dsPIC30
• Maximum Speed: 30 MHz
• Operating Supply Voltage: 3.3|5 V
• Data Bus Width: 16 Bit
• Number Of Programmable I/os: 21
• Interface Type: I2C/SPI/UART
• On-chip Adc: 8-chx10-bit
• Number Of Timers: 3
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With: DM300023 - KIT DEMO DSPICDEM SMPS BUCKAC164322 - MODULE SOCKET MPLAB PM3 28/44QFNDV164005 - KIT ICD2 SIMPLE SUIT W/USB CABLE
• Eeprom Size: -
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

11. Module: PWM Override Enable
© 2008 Microchip Technology Inc.
The OVRDAT<1:0> bits in the IOCONx register
should determine the state of the PWMx output
pins when the OVRENH and OVRENL bits
(IOCONx<9:8>) are set. However, the PWM
override feature does not work correctly. The
PWMxH and PWMxL pins do not exhibit the state
specified by the OVRDAT<1:0> bits when only one
of the override bits (OVRENH or OVRENL) is set.
If both bits are set, the override state is exhibited
correctly on the PWMxL and PWMxH pins.
Work around
If override capability is desired on only one of the
PWM pin pairs, use the GPIO module to override
the PWM outputs. This can be done using the
PENH and PENL bits in the IOCONx register.
When the PENH/PENL bits in the IOCONx
register. When the PENH/PENL bits are cleared,
the GPIO module assumes control of the
PWMxH/L output pin. The GPIO module must be
set up in advance for the desired override output
states, and the pins must be configured as digital
outputs. This includes setting the PORTx and
TRISx registers correctly, which correspond to the
PWMxH and PWMxL pins.
dsPIC30F1010/202X
DS80290J-page 7