DSPIC30F4011-30I/ML Microchip Technology, DSPIC30F4011-30I/ML Datasheet - Page 159
![IC DSPIC MCU/DSP 48K 44QFN](/photos/6/81/68122/150-44-qfn_sml.jpg)
DSPIC30F4011-30I/ML
Manufacturer Part Number
DSPIC30F4011-30I/ML
Description
IC DSPIC MCU/DSP 48K 44QFN
Manufacturer
Microchip Technology
Series
dsPIC™ 30Fr
Datasheets
1.DSPIC30F4012-30ISO.pdf
(238 pages)
2.DSPIC30F4012-30ISO.pdf
(18 pages)
3.DSPIC30F4012-30ISO.pdf
(6 pages)
4.DSPIC30F4012-30ISO.pdf
(16 pages)
5.DSPIC30F4012-30ISO.pdf
(22 pages)
Specifications of DSPIC30F4011-30I/ML
Core Processor
dsPIC
Core Size
16-Bit
Speed
30 MIPs
Connectivity
CAN, I²C, SPI, UART/USART
Peripherals
Brown-out Detect/Reset, Motor Control PWM, QEI, POR, PWM, WDT
Number Of I /o
30
Program Memory Size
48KB (16K x 24)
Program Memory Type
FLASH
Eeprom Size
1K x 8
Ram Size
2K x 8
Voltage - Supply (vcc/vdd)
2.5 V ~ 5.5 V
Data Converters
A/D 9x10b
Oscillator Type
Internal
Operating Temperature
-40°C ~ 85°C
Package / Case
44-QFN
Core Frequency
40MHz
Core Supply Voltage
5.5V
Embedded Interface Type
CAN, I2C, SPI, UART
No. Of I/o's
30
Flash Memory Size
48KB
Supply Voltage Range
2.5V To 5.5V
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
For Use With
XLT44QFN2 - SOCKET TRAN ICE 44QFN/40DIPAC164322 - MODULE SOCKET MPLAB PM3 28/44QFNDV164005 - KIT ICD2 SIMPLE SUIT W/USB CABLE
Lead Free Status / RoHS Status
Lead free / RoHS Compliant, Lead free / RoHS Compliant
Other names
DSPIC30F401130IML
- DSPIC30F4012-30ISO PDF datasheet
- DSPIC30F4012-30ISO PDF datasheet #2
- DSPIC30F4012-30ISO PDF datasheet #3
- DSPIC30F4012-30ISO PDF datasheet #4
- DSPIC30F4012-30ISO PDF datasheet #5
- Current page: 159 of 238
- Download datasheet (4Mb)
21.3.1.1
The oscillator start-up circuitry is not linked to the POR
circuitry. Some
frequency crystals) have a relatively long start-up time.
Therefore, one or more of the following conditions is
possible after the POR timer and the PWRT have
expired:
• The oscillator circuit has not begun to oscillate.
• The Oscillator Start-up Timer has not expired (if a
• The PLL has not achieved a lock (if PLL is used).
If the FSCM is enabled and one of the above conditions
is true, then a clock failure trap occurs. The device
automatically switches to the FRC oscillator and the
user can switch to the desired crystal oscillator in the
trap ISR.
21.3.1.2
If the FSCM is disabled and the Power-up Timer
(PWRT) is also disabled, then the device exits rapidly
from Reset on power-up. If the clock source is FRC,
LPRC, ERC or EC, it will be active immediately.
If the FSCM is disabled and the system clock has not
started, the device will be in a frozen state at the Reset
vector until the system clock starts. From the user’s
perspective, the device will appear to be in Reset until
a system clock is available.
21.3.2
The BOR (Brown-out Reset) module is based on an
internal voltage reference circuit. The main purpose of
the BOR module is to generate a device Reset when a
brown-out condition occurs. Brown-out conditions are
generally caused by glitches on the AC mains (i.e.,
missing portions of the AC cycle waveform due to bad
power transmission lines, or voltage sags due to exces-
sive current draw when a large inductive load is turned
on).
The BOR module allows selection of one of the
following voltage trip points (see
• 2.6V-2.71V
• 4.1V-4.4V
• 4.58V-4.73V
© 2010 Microchip Technology Inc.
crystal oscillator is used).
Note:
BOR: PROGRAMMABLE
BROWN-OUT RESET
The BOR voltage trip points indicated here
are nominal values provided for design
guidance only.
POR with Long Crystal Start-up Time
(with FSCM Enabled)
Operating without FSCM and PWRT
crystal circuits (especially low-
Table
24-10):
A BOR generates a Reset pulse, which resets the
device. The BOR selects the clock source, based on
the device Configuration bit values (FOS<1:0> and
FPR<3:0>). Furthermore, if an oscillator mode is
selected, the BOR activates the Oscillator Start-up
Timer (OST). The system clock is held until OST
expires. If the PLL is used, then the clock is held until
the LOCK bit (OSCCON<5>) is ‘1’.
Concurrently, the POR time-out (T
time-out (T
is released. If T
being used, then a nominal delay of T
applied. The total delay in this case is (T
The BOR status bit (RCON<1>) is set to indicate that a
BOR has occurred. The BOR circuit, if enabled, contin-
ues to operate while in Sleep or Idle modes and resets
the device if V
FIGURE 21-6:
Note:
Note 1: External Power-on Reset circuit is required
dsPIC30F4011/4012
2: R should be suitably chosen so as to make
3: R1 should be suitably chosen so as to limit
PWRT
D
Dedicated supervisory devices, such as
the MCP1XX and MCP8XX, may also be
used as an external Power-on Reset
circuit.
only if the V
The diode D helps discharge the capacitor
quickly when V
sure that the voltage drop across R does not
violate the device’s electrical specification.
any current flowing into MCLR from external
capacitor C, in the event of MCLR pin break-
down, due to Electrostatic Discharge (ESD)
or Electrical Overstress (EOS).
DD
V
) are applied before the internal Reset
PWRT
falls below the BOR threshold voltage.
DD
R
C
EXTERNAL POWER-ON
RESET CIRCUIT (FOR
SLOW V
= 0 and a crystal oscillator is
DD
DD
R1
power-up slope is too slow.
powers down.
DD
MCLR
dsPIC30F
POR
DS70135G-page 159
POWER-UP)
FSCM
) and the PWRT
POR
= 100 μs is
+ T
FSCM
).
Related parts for DSPIC30F4011-30I/ML
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
![MA300012](/photos/26/93/269359/ma300012_tmb.jpg)
Part Number:
Description:
MODULE DSPIC30F SAMPLE 64QFP
Manufacturer:
Microchip Technology
Datasheet:
![MA300013](/photos/26/93/269388/ma300013_tmb.jpg)
Part Number:
Description:
MODULE DSPIC30F SAMPLE 80QFP
Manufacturer:
Microchip Technology
Datasheet:
![SW006013](/photos/9/32/93254/sw006013_tmb.jpg)
Part Number:
Description:
MPLAB C Compiler For DsPIC DSCs
Manufacturer:
Microchip Technology
Datasheet:
![DAF30-3](/photos/26/88/268854/daf30_3_tmb.jpg)
Part Number:
Description:
DEVICE ATP FOR ICE4000
Manufacturer:
Microchip Technology
Datasheet:
![DAF30-4](/photos/26/91/269107/daf30_4_tmb.jpg)
Part Number:
Description:
DEVICE ATP FOR ICE4000
Manufacturer:
Microchip Technology
Datasheet:
![DAF30-2](/photos/26/92/269222/daf30_2_tmb.jpg)
Part Number:
Description:
DEVICE ATP FOR ICE4000
Manufacturer:
Microchip Technology
Datasheet:
![MA18F4431](/images/manufacturer_photos/0/4/439/microchip_technology_tmb.jpg)
Part Number:
Description:
MODULE PLUG-IN PIC18F4431
Manufacturer:
Microchip Technology
Datasheet:
![DSPIC30F2020-20E/SO](/images/manufacturer_photos/0/4/439/microchip_technology_tmb.jpg)
Part Number:
Description:
IC, DSC, 16BIT, 12KB 40MHZ, 5.5V, SOIC28
Manufacturer:
Microchip Technology
Datasheet:
![DSPIC30F3014-20I/PT](/photos/6/82/68251/c04-076_pt_tmb.jpg)
Part Number:
Description:
IC, DSC, 16BIT, 24KB 40MHZ, 5.5V, TQFP44
Manufacturer:
Microchip Technology
Datasheet:
![DSPIC30F4011-20E/P](/photos/6/61/66192/150-40-dip_tmb.jpg)
Part Number:
Description:
IC, DSC, 16BIT, 48KB, 40MHZ, 5.5V, DIP40
Manufacturer:
Microchip Technology
Datasheet:
![DSPIC30F4012-20I/SO](/images/manufacturer_photos/0/4/439/microchip_technology_tmb.jpg)
Part Number:
Description:
IC, DSC, 16BIT, 48KB 20MHZ, 5.5V, SOIC28
Manufacturer:
Microchip Technology
Datasheet:
![DSPIC30F5011-20I/PTG](/images/manufacturer_photos/0/4/439/microchip_technology_tmb.jpg)
Part Number:
Description:
IC, DSC, 16BIT, 66KB, 40MHZ 5.5V TQFP-64
Manufacturer:
Microchip Technology
Datasheet:
![DSPIC30F2012-30I/ML](/photos/6/81/68120/150-28-qfn_tmb.jpg)
Part Number:
Description:
IC, DSC, 16BIT, 12KB, 40MHZ, 5.5V, QFN28
Manufacturer:
Microchip Technology
Datasheet:
![DSPIC30F2010-30I/SPG](/photos/19/0/190081/42268255_tmb.jpg)
Part Number:
Description:
16BIT 30MIPS DSPIC, 30F2010, DIP28
Manufacturer:
Microchip Technology
Datasheet:
![DSPIC30F5011-30I/PTG](/photos/19/3/190367/42268274_tmb.jpg)
Part Number:
Description:
16BIT MCU-DSP 30MHZ, SMD, 30F5011
Manufacturer:
Microchip Technology
Datasheet: