G6HU-2-DC5 Omron, G6HU-2-DC5 Datasheet - Page 8

• Manufacturer Part Number: G6HU-2-DC5
• Description: RELAY LATCH DPDT 5VDC T/H
• Manufacturer: Omron
• Series: G6Hr

Specifications of G6HU-2-DC5

• Coil Type: Latching, Single Coil
• Coil Current: 20mA
• Relay Type: Telecom
• Circuit: DPDT (2 Form C)
• Contact Rating @ Voltage: 1A @ 30VDC
• Coil Voltage: 5VDC
• Control On Voltage (max): 3.75 VDC
• Mounting Type: Through Hole
• Termination Style: PC Pin
• Contact Configuration: DPDT
• Contact Current Max: 1A
• Contact Voltage Ac Nom: 125V
• Contact Voltage Dc Nom: 30V
• Coil Voltage Vdc Nom: 5V
• Coil Resistance: 250ohm
• Contact Form: 2 Form C
• Power Consumption: 100 mW
• Maximum Switching Current: 1 A
• Contact Rating: 0.50 A at 125 VAC, 1 A at 30 VDC
• Current, Rating: 0.5⁄1 AAC⁄ADC
• Function: Latching
• Number Of Pins: 10
• Power, Rating: 62.5⁄33 VA⁄W
• Standards: UL, CSA, RoHS
• Voltage, Control: 5 VDC
• Voltage, Rating: 125 VAC
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Control Off Voltage (min): -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: G6HU-2-DC5; G6HU2DC5; Z3031

Precautions
Long-term Continuously ON Contacts
Using the Relay in a circuit where the Relay will be ON continuously
for long periods (without switching) can lead to unstable contacts
because the heat generated by the coil itself will affect the insulation,
causing a film to develop on the contact surfaces. We recommend
using a latching relay (magnetic-holding relay) in this kind of circuit. If
a single-side stable model must be used in this kind of circuit, we rec-
ommend using a fail-safe circuit design that provides protection
against contact failure or coil burnout.
Claw Securing Force During Automatic Mounting
During automatic insertion of Relays, be sure to set the securing
force of each claw to the following so that the Relay’s characteristics
will be maintained.
56
Direction A: 1.96 N max.
Direction B: 4.90 N max.
Direction C: 1.96 N max.
A
C
B
Low Signal Relay
G6H
DISCONTINUED
Relay Handling
Use the Relay as soon as possible after opening the moisture-proof
package. If the Relay is left for a long time after opening the mois-
ture-proof package, the appearance may deteriorate and seal failure
may occur after the solder mounting process. To store the Relay after
opening the moisture-proof package, place it into the original pack-
age and seal the package with adhesive tape.
When washing the product after soldering the Relay to a PCB, use a
water-based solvent or alcohol-based solvent, and keep the solvent
temperature to less than 40°C. Do not put the Relay in a cold clean-
ing bath immediately after soldering.