TOOLSTICK540DC Silicon Laboratories Inc, TOOLSTICK540DC Datasheet - Page 4

• Manufacturer Part Number: TOOLSTICK540DC
• Description: DAUGHTER CARD TOOLSTICK F540
• Manufacturer: Silicon Laboratories Inc
• Series: ToolStickr
• Type: MCUr

Specifications of TOOLSTICK540DC

• Contents: Daughter Card
• Processor To Be Evaluated: C8051F54x
• Processor Series: C8051F54x
• Interface Type: USB
• Operating Supply Voltage: 2.7 V to 3.6 V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: C8051F54x
• For Use With: 336-1345 - TOOLSTICK BASE ADAPTER336-1182 - ADAPTER USB DEBUG FOR C8051FXXX
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 336-1717

ToolStick-F 54 0DC
5.2. Keil Demonstration Toolset
5.2.1. Keil Assembler and Linker
The Keil demonstration toolset assembler and linker place no restrictions on code size.
5.2.2. Keil Demonstration C51 C Compiler
The evaluation version of the C51 compiler is the same as the full version with the following limitations:



5.3. Configuration Wizard 2
The Configuration Wizard 2 is a code generation tool for all of the Silicon Labs devices. Code is generated through
the use of dialog boxes for each of the device's peripherals.
The Configuration Wizard 2 utility helps accelerate development by automatically generating initialization source
code to configure and enable the on-chip resources needed by most design projects. In just a few steps, the wizard
creates complete startup code for a specific Silicon Labs MCU. The program is configurable to provide the output
in C or assembly.
For more information, please refer to the Configuration Wizard 2 documentation. The documentation and software
are available from the Downloads webpage (www.silabs.com/mcudownloads).
4
Maximum 4 kB code generation
There is no floating point library installed
When initially installed, the C51 compiler is limited to a code size of 2 kB, and programs start at code address
0x0800. Refer to “AN104: Integrating Keil Tools into the Silicon Labs IDE” for instructions to change the
limitation to 4 kB and have the programs start at code address 0x0000.
Figure 4. Configuration Wizard 2 Utility
Rev. 0.1