STEVAL-PCC010V1 STMicroelectronics, STEVAL-PCC010V1 Datasheet - Page 8

• Manufacturer Part Number: STEVAL-PCC010V1
• Description: BOARD EVAL FOR ST802RT1
• Manufacturer: STMicroelectronics

Specifications of STEVAL-PCC010V1

• Main Purpose: Interface, Ethernet Controller (PHY and MAC)
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: ST802RT1
• Primary Attributes: 1 Port, 100BASE-TX/10BASE-T
• Secondary Attributes: MII, RMII
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 497-10360

UM0819
4
4.1
4.2
Getting started
This section briefly describes how to start using the STEVAL-PCC010V1 ST802RT1 TX
mode Ethernet PHY demonstration kit. To use this demonstration kit you must install
a web browser on your computer.
Package contents
The ST802RT1 TX mode Ethernet PHY demonstration kit includes the following items:
Hardware content
●
●
Software content
●
Documentation
●
●
How to run the demonstration software
This section describes the demonstration software delivered with the ST802RT1 TX mode
Ethernet PHY demonstration kit. The software implements a simple web server based on
uIP TCP/IP stack. The web server consists of three pages displaying general information
about the STM32 and ST802RT1 TX mode, allowing to control LEDs on the STM32F107
controller board and finally showing the content of the ST802RT1 TX mode registers.
To run the demonstration software, you need a demonstration kit, an Ethernet cable, and
a PC with a web browser.
Follow the steps below:
1.
One ST802RT1 TX mode Ethernet PHY demonstration board
One STM32F107 controller demonstration board
Web server - demonstration software based on uIP TCP/IP stack
STM32F107xx datasheet, ST802RT1 product documentation
This user manual
Connect the boards delivered in the package as shown on the
Doc ID 16379 Rev 2
Figure
4.
Getting started
8/37