PL-BYTEBLASTER2N Altera, PL-BYTEBLASTER2N Datasheet - Page 13

• Manufacturer Part Number: PL-BYTEBLASTER2N
• Description: CABLE PROGRAMMING PARALLEL PORT
• Manufacturer: Altera
• Series: ByteBlaster™r

Specifications of PL-BYTEBLASTER2N

• Accessory Type: Download Cable
• Core Architecture: FPGA
• Core Sub-architecture: Arria, Cyclone, Stratix
• Ic Product Type: Debugger / Programmer
• Kit Contents: Device, Cable, Guides
• Rohs Compliant: Yes
• For Use With/related Products: EPCS Serial Configuration Devices
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 544-1289; PL-BYTEBLASTER2

Chapter 1: Setting Up the ByteBlaster II Download Cable
Software Setup
Setting Up the ByteBlaster II Hardware in the Quartus II Software
© July 2008 Altera Corporation
3. Run the configure install script by typing the following command at the command
4. Compile the Altera ByteBlaster kernel driver by typing the following command at
5. Become root and compile the Altera ByteBlaster kernel driver module and device
6. To install the Altera ByteBlaster kernel driver, type the following command at the
7. To determine whether the ByteBlaster II download cable and the Altera
You should see a list of devices on your JTAG chain, including the ByteBlaster II
download cable.
To set up the ByteBlaster II hardware in the Quartus II software, perform the
following steps:
1. Start the Quartus II software.
2. On the Tools menu, click Programmer.
3. Click Hardware Setup. The Hardware Settings tab of the Hardware Setup dialog
4. In the Currently selected hardware list, select ByteBlasterII [LPT1].
5. Click Add Hardware. The Add Hardware dialog box appears. Select ByteBlaster
6. ByteBlasterII is now visible in the Available hardware items list of the Hardware
prompt:
./configure r
the command prompt:
make r
nodes by typing the following command at the command prompt:
make install r
command prompt:
jtagconfig --add byteblaster2 /dev/byteblaster0 r
ByteBlaster kernel driver are installed correctly, display a list of available devices
by typing the following command at the command prompt:
jtagconfig r
box appears.
MV or ByteBlaster II and click OK.
Setup dialog box, as shown in
Figure
1–2.
ByteBlaster II Download Cable User Guide
1–5