BTS5230GS Infineon Technologies, BTS5230GS Datasheet - Page 21

• Manufacturer Part Number: BTS5230GS
• Description: IC HIGH SIDE PWR SWITCH PDSO-14
• Manufacturer: Infineon Technologies
• Series: PROFET®r
• Type: High Sider

Specifications of BTS5230GS

• Input Type: Non-Inverting
• Number Of Outputs: 2
• On-state Resistance: 140 mOhm
• Current - Output / Channel: 1.8A
• Current - Peak Output: 10A
• Voltage - Supply: 4.5 V ~ 28 V
• Operating Temperature: -40°C ~ 150°C
• Mounting Type: Surface Mount
• Package / Case: DSO-14
• Switch Type: High Side
• Power Switch Family: BTS 5230GS
• Input Voltage: -5 to 10V
• Power Switch On Resistance: 140mOhm
• Output Current: 1.8A
• Mounting: Surface Mount
• Package Type: DSO
• Operating Temperature (min): -40C
• Operating Temperature (max): 150C
• Operating Temperature Classification: Automotive
• Pin Count: 14
• Power Dissipation: 900W
• For Use With: DEMOBOARDPROFETIN - BOARD DEMO PROFET V2.0BTS
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: BTS5230GST; SP000082241

I
There is no internal leakage current from out to ground at BTS 5230GS.
minimum supply voltage at which the open load diagnosis in off state must be ensured.
To reduce the stand-by current of the system, an open load resistor switch (
recommended.
4.3.3
The diagnosis signals have to be switched on by a high signal at sense enable pin (SEN).
See
Please note that the diagnosis is enabled, when no signal is provided at pin SEN.
Figure 17
The SEN pin circuit is designed equal to the input pin. Please refer to
The resistors
IS2 in case of reverse polarity and over-voltage. Please refer to maximum ratings on
Page
The stand-by current of the BTS 5230GS is minimized, when both input pins (IN1 and
IN2) and the sense enable pin (SEN) are on low level.
Data Sheet
leakage
Figure 17
SEN
8.
I
IS
defines the leakage current in the complete system e.g. caused by humidity.
Sense Enable Function
t
sIS(SEN)
R
Timing of Sense Enable Signal
lim
for details on the timing between SEN pin and diagnosis signal
are recommended to limit the current through the sense pins IS1 and
t
dIS(SEN)
R
OL
=
V
---------------------------------------------------------- -
bb(min)
21
I
–
leakage
V
OUT(OL,max)
Smart High-Side Power Switch
t
sIS(SEN)
t
dIS(SEN)
Figure 5
V2.0, 2005-06-13
BTS 5230GS
V
bb(min)
t
t
for details.
S
SEN.emf
OL
is the
) is
I
IS
.