tc9256afg TOSHIBA Semiconductor CORPORATION, tc9256afg Datasheet - Page 13

• Manufacturer Part Number: tc9256afg
• Description: Pll For Dts
• Manufacturer: TOSHIBA Semiconductor CORPORATION

(3)
(4)
(5)
(6)
Bits M7, M8 and M9 ................. M7 (*1) sets the state for pin I/O-7/SC
Note1:
Note2:
Note3:
Bits f0 to f19.............................. The general-purpose counter results can be read in binary from bits f0
OVER and BUSY bits............... Detect the operating state of the general-purpose counter.
Note:
START bit ................................. When the data is set to “1”, the general-purpose counter is reset; then
These operations are valid when bits SC, IF1 and IF2 are all set to 1.
Bit names in parentheses “( )” apply to the TC9256APG and TC9256AFG.
When using the general-purpose counter, confirm that the BUSY bit is “0” (counting is ended) and
the OVER bit is “0” (general-purpose counter data is normal) before referring to the contents of the
general-purpose counter result bits (f0 to f19).
Bits marked with an asterisk “(*)” are don’t-care.
Bits marked with (*1) cannot be set on the TC9256APG and TC9256AFG.
I/O-8/IF
to f19 of the output register (D1H).
counting start.
IN1
13
; M9 (M6), for pin I/O-9/IF
IN
IN2
TC9256, 57APG/AFG
; M8 (M5) sets the state for pin
.
2006-07-14