hdd128m72d18rpw ETC-unknow, hdd128m72d18rpw Datasheet - Page 10

• Manufacturer Part Number: hdd128m72d18rpw
• Description: Sdram Module 1024mbyte 128mx72bit , Based 64mx8, 4banks, Ref., 184pin-dimm With Register
• Manufacturer: ETC-unknow

HANBit
Component Notes
1. tHZ and tLZ transitions occur in the same access time windows as valid data transitions. these parameters are not referenced to
2. The maximum limit for this parameter is not a device limit. The device will operate with a greater value for this parameter, but
3. The specific requirement is that DQS be valid (HIGH, LOW, or at some point on a valid transition) on or before this CK edge.
4. A maximum of eight AUTO REFRESH commands can be posted to any given DDR SDRAM device.
5. For command/address input slew rate ≥
6. For command/address input slew rate ≥
7. For CK & CK slew rate ≥
8. These parameters guarantee device timing, but they are not necessarily tested on each device. They may be guaranteed by
9. Slew Rate is measured between VOH(ac) and VOL(ac).
10. Min (tCL, tCH) refers to the smaller of the actual clock low time and the actual clock high time as provided to the device (i.e. this
11. tQH = tHP - tQHS, where:
12. tDQSQ
13. tDAL = (tWR/tCK) + (tRP/tCK)
URL : www.hbe.co.kr
REV 1.0 (January. 2005)
a specific voltage level but specify when the device output in no longer driving (HZ), or begins driving (LZ).
system performance (bus turnaround) will degrade accordingly.
A valid transition is defined as monotonic and meeting the input slew rate specifications of the device. when no writes were
previously in progress on the bus, DQS will be tran sitioning from High- Z to logic LOW. If a previous write was in progress, DQS
could be HIGH, LOW, or transitioning from HIGH to LOW at this time, depending on tDQSS.
device design or tester correlation.
value can be greater than the minimum specification limits for tCL and tCH).....For example, tCL and tCH are = 50% of the
period, less the half period jitter (tJIT(HP)) of the clock source, and less the half period jitter due to crosstalk (tJIT(crosstalk)) into
the clock traces.
tHP = minimum half clock period for any given cycle and is defined by clock high or clock low (tCH, tCL). tQHS accounts for 1)
The pulse duration distortion of on-chip clock circuits; and 2) The worst case push-out of DQS on one tansition followed by the
worst case pull-in of DQ on the next transition, both of which are, separately, due to data pin skew and output pattern effects, and
pchannel to n-channel variation of the output drivers.
Consists of data pin skew and output pattern effects, and p-channel to n-channel variation of the output drivers for any given
cycle.
For each of the terms above, if not already an integer, round to the next highest integer. Example: For DDR266B at CL=2.5 and
tCK=7.5ns tDAL = (15 ns / 7.5 ns) + (20 ns/ 7.5ns) = (2) + (3)
tDAL = 5 clocks
1.0 V/ns
1.0 V/ns
0.5 V/ns and < 1.0 V/ns
10
HDD128M72D18RPW
HANBit Electronics Co.,Ltd.