h7cx-a114-n Omron Corporation, h7cx-a114-n Datasheet - Page 35

• Manufacturer Part Number: h7cx-a114-n
• Description: Multifunction Counter/tachometer
• Manufacturer: Omron Corporation

Switching between Preset Counter, Total and Preset Counter, Batch Counter, Dual
Counter, Twin Counter, and Tachometer Operation
Select which H7CX configuration is used (i.e., preset counter, total and preset counter, batch counter, dual counter, twin counter, or tachometer)
in configuration selection mode.
The H7CX is also equipped with a DIP switch monitor function, a convenient function that enables the settings of the DIP switch pins to be
confirmed using the display on the front of the H7CX.
Hold Function
The measurement value (display value) and output are sustained while the hold input is ON.
Note: The output will maintain the current status when the hold key is pressed.
Example:
*1 When the mode is changed to configuration selection mode, the present value is reset, outputs turn OFF, and counting (measuring) stops.
*2 Setting changes made in configuration selection mode are enabled when the mode is changed to run mode. If the configuration is changed, the
set value (or set value 1 and set value 2), comparison value 1 and comparison value 2 are initialized.
Output mode
Lower limit
setting
*2
Comparison value (lower limit)
Power ON
key for 1 s
Press the
Hold input* (Reset Key)
min.
+
1
Display value
*1
Configuration
selection
DIP switch
monitor
(DIP)
OUT
Operation
Note
Select the configuration using the UD Key.
*The configurations that can be selected depend on the model.
Note: By default, the H7CX is set to the 1-stage preset counter configuration. (Two-stage
Confirm the status of DIP switch pins 1 to 8 using the UD Key.
*This display is possible only when DIP switch pin 1 (DIP switch settings enable/disable)
To change the mode to configuration selection mode, hold
down the
The mode will not change if the
is set to ON (enable).
OFF
ON
1cnt
(1-stage
preset
counter)
Key
Example
models are set to the 2-stage preset counter configuration.)
1 2 3 4 5 6 7 8
Actual input
1
2cnt
(2-stage
preset
counter)
Key for 1 s min. with the
Sustained output
Sustained display value
(Total and
preset counter)
tcnt
1
Key
Key is pressed first.
(Batch
counter)
bcnt
1
Key
Key held down.
…Indicates that DIP switch pin 8 is ON.
…Indicates that DIP switch pin 7 is OFF.
…Indicates that DIP switch pin 6 is ON.
…Indicates that DIP switch pin 5 is OFF.
…Indicates that DIP switch pin 4 is ON.
…Indicates that DIP switch pin 3 is OFF.
…Indicates that DIP switch pin 2 is ON.
…Indicates that DIP switch pin 1 is ON.
dcnt
(Dual
counter)
RST
H7CX-A@-N
(Twin
counter)
twn
(Tachometer)
taco
Key
1
35