MAX16051 Maxim Integrated Products, MAX16051 Datasheet - Page 13

• Manufacturer Part Number: MAX16051
• Description: Voltage Monitors/Sequencer Circuits
• Manufacturer: Maxim Integrated Products

Figure 5. Typical Connection for Sequencing Four DC-DC Converters
The MAX16050 monitors up to 5 voltages (Figure 5) with
the ability to sequence up to 4 voltages, while the
MAX16051 monitors up to 6 voltages with the ability to
sequence up to 5 voltages. These devices control sys-
tem power-up and power-down in a particular
sequence order. The MAX16050/MAX16051 turn off all
supplies and assert a reset to the processor when any
of the voltages falls below its respective threshold. The
MAX16050/MAX16051 offer an 85mA pulldown feature
that helps discharge the output capacitance of DC-DC
converters to ensure timely power-down. In addition, the
MAX16050/MAX16051 also reverse sequence, monitor-
ing each power-supply output voltage present at the
associated DISC_ input and ensuring that the voltage
falls below 250mV before turning off the next supply.
The MAX16050 provides three sequence logic inputs,
which select the sequence order from 24 possible
OFF
V
BUS
ON
Voltage Monitors/Sequencer Circuits with
DC-DC
______________________________________________________________________________________
SHDN
V
EN
GND
EN
CC
Detailed Description
DC-DC
EN
Reverse-Sequencing Capability
MAX16050
DC-DC
EN
combinations (Table 1). In the default mode (SEQ1 =
SEQ2 = SEQ3 = High Impedance), the power-up
sequence is OUT1→OUT2→OUT3→OUT4. The
MAX16051 features an additional channel and the
sequence order is fixed at OUT1→OUT2→OUT3
→OUT4→OUT5. For complex systems with a large
number of power supplies, the MAX16050/MAX16051
can be used in a daisy-chain configuration. Reverse
sequencing in the daisy-chained configuration is still
possible.
The MAX16050/MAX16051 keep all OUT_ low (all of the
supplies in the off-state) until four conditions are met.
1) The voltage at ABP exceeds the undervoltage lock-
2) The voltage at the analog enable input (EN) is
3) The shutdown input, SHDN, is not asserted.
4) All DISC_ voltages must be below 250mV.
out threshold.
above its threshold.
DC-DC
EN
OV_OUT
FAULT
RESET
REM
V2
V1
V3
V4
www.DataSheet4U.com
V
PU
13