BTM 7755G Infineon Technologies, BTM 7755G Datasheet - Page 17

• Manufacturer Part Number: BTM 7755G
• Manufacturer: Infineon Technologies

Specifications of BTM 7755G

• Packages: PG-DSO-36
• Operating Range: 5.5 - 28.0 V
• Rds (on) (typ): 150.0 mOhm
• Id(lim): 12.0 A
• Iq (typ): 5.0 µA
• Diagnosis: OV-, OC-, OT-failure flag

6.4
6.4.1
The control inputs INx and INH consist of TTL/CMOS compatible schmitt triggers with hysteresis which control the
integrated gate drivers for the MOSFETs. To set the device in stand-by mode, INH and INx pins need to be all
connected to GND. When the INH is high, in each half bridge one of the two power switches (HSx or LSx) is
switched on, while the other power switch is switched off, depending on the status of the INx pin. When INH is low,
a high INx signal will turn the corresponding highside switches on. This provides customer the possibility to switch
on one high side switch while keeping the other switches off and therefore to do an open load detection together
with external circuitry (see also
both power switches. To drive the logic inputs no external driver is needed, therefore the BTM7755G can be
interfaced directly to a microcontroller.
6.4.2
In bridge applications it has to be assured that the highside and lowside MOSFET are not conducting at the same
time, connecting directly the battery voltage to GND. This is assured by a circuit in the driver IC, which senses the
status of the MOSFETs to ensure that the high or low side switch can be switched on only if the corresponding
low or high side switch is completely turned off.
6.4.3
The status pin provides diagnostic signal of the device. It is an open drain output which requires a pull-up resistor.
In case of overvoltage, overtemperature and overcurrent situation the status output is switched to low. In case of
current limitation the status output is activated for 1.5 *
Data Sheet
Status Flag Diagnosis
Control and Diagnostics
Input Circuit
Dead Time Generation
Chapter 7
- Application Information). A low on all INx and INH signal will turn off
17
t
CLS
.
Block Description and Characteristics
High Current H-Bridge
Rev. 2.0, 2010-05-28
BTM7755G