ATxmega192A3U Atmel Corporation, ATxmega192A3U Datasheet - Page 407

• Manufacturer Part Number: ATxmega192A3U
• Manufacturer: Atmel Corporation

Specifications of ATxmega192A3U

• Flash (kbytes): 192 Kbytes
• Pin Count: 64
• Max. Operating Frequency: 32 MHz
• Cpu: 8-bit AVR
• # Of Touch Channels: 16
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 50
• Ext Interrupts: 50
• Usb Transceiver: 1
• Usb Speed: Full Speed
• Usb Interface: Device
• Spi: 10
• Twi (i2c): 2
• Uart: 7
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 16
• Adc Resolution (bits): 12
• Adc Speed (ksps): 2000
• Analog Comparators: 4
• Resistive Touch Screen: No
• Dac Channels: 2
• Dac Resolution (bits): 12
• Temp. Sensor: Yes
• Crypto Engine: AES/DES
• Sram (kbytes): 16
• Eeprom (bytes): 2048
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: Yes
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.6 to 3.6
• Operating Voltage (vcc): 1.6 to 3.6
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 7
• Output Compare Channels: 22
• Input Capture Channels: 22
• Pwm Channels: 22
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

31.5
31.5.1
8331A–AVR–07/11
Boundary Scan Chain
Scanning the Port Pins
The active states are:
The boundary scan chain has the capability of driving and observing the logic levels on the I/O
pins. To ensure a predictable device behavior during and after the EXTEST, CLAMP, and
HIGHZ instructions, the device is automatically put in reset. During active reset, the external
oscillators, analog modules, and non-default port pin settings (like pull-up/down, bus-keeper,
wired-AND/OR) are disabled. It should be noted that the current device and port pin state are
unaffected by the SAMPLE and PRELOAD instructions.
Figure 31-2 on page 407
This cell is able to control and observe both pin direction and pin value via a two-stage shift reg-
ister. When no alternate port function is present, output control corresponds to the DIR register
value, output data corresponds to the OUT register value, and input data corresponds to the IN
register value (tapped before the input inverter and input synchronizer). Mode represents either
an active CLAMP or EXTEST instruction, while shift DR is set when the TAP controller is in its
shift DR state.
Figure 31-2. Bidirectional boundary scan cell.
• Capture DR: Parallel data from the PDI are sampled into the PDICOM data register
• Shift DR: The PDICOM data register is shifted by the TCK input
• Update DR: Commands or operands are parallel-latched from the PDICOM data register into
the PDI
Output Data
Output Control
Input Data
(IN)
(IN)
(DIR)
shows the boundary scan cell used for all the bidirectional port pins.
Mode
0
1
0
1
From last cell Clock DR
Shift DR
0
1
0
1
Atmel AVR XMEGA AU
To next cell
D
D Q
Update DR
Q
D
D Q
Q
En
Pn
407