AT86RF231 Atmel Corporation, AT86RF231 Datasheet - Page 58
AT86RF231
Manufacturer Part Number
AT86RF231
Description
Manufacturer
Atmel Corporation
Datasheet
1.AT86RF231.pdf
(198 pages)
Specifications of AT86RF231
Max. Operating Frequency
0 MHz
Crypto Engine
AES
Operating Voltage (vcc)
1.8 to 3.6
Frequency Band
2.4 GHz
Max Data Rate (mb/s)
2
Antenna Diversity
Yes
External Pa Control
Yes
Power Output (dbm)
3
Receiver Sensitivity (dbm)
-101
Receive Current Consumption (ma)
13.2
Transmit Current Consumption (ma)
14.4
Link Budget (dbm)
104
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Part Number:
AT86RF231-ZU
Manufacturer:
ATMEL/爱特梅尔
Quantity:
20 000
- Current page: 58 of 198
- Download datasheet (5Mb)
7.2.3.3
8111C–MCU Wireless–09/09
Configuration of non IEEE 802.15.4 Compliant Scenarios
Sniffer
Table 7-9 on page 58
RX_AACK configuration bits, refer to
All frames received are indicated by an IRQ_2 (RX_START) and IRQ_3 (TRX_END). After
frame reception register bit RX_CRC_VALID (register 0x06, PHY_RSSI) is updated with the
result of the FCS check (see
RX_CRC_VALID bit needs to be checked in order to dismiss corrupted frames.
Table 7-9.
This operating mode is similar to the promiscuous mode.
Reception of Reserved Frames
In RX_AACK mode, frames with reserved frame types, refer to
Field (FCF)” on page
etary, non-standard compliant, protocols. It is an extension of the address filtering in RX_AACK
mode. Received frames are either handled similar to data frames, or may be allowed to com-
pletely bypass the address filter.
Table 7-10 on page 58
Figure 7-9 on page 53
Table 7-10.
0x20,0x21
0x22,0x23
Register
Address
Register
Address
...........
0x24,
0x0C
0x2C
0x2E
0x2B
0x17
0x17
0x17
Register
Register
Configuration of a Sniffer Device
RX_AACK Configuration to Receive Reserved Frame Types
Bits
Bits
4
7
5
0
1
4
80, can also be handled. This might be required when implementing propri-
shows the corresponding flow chart.
shows the required configuration for a node to receive reserved frames,
shows an RX_AACK configuration to setup a sniffer device. Other
Register Name
AACK_PROM_MODE
AACK_DIS_ACK
Register Name
SHORT_ADDR_0/1
PAN_ADDR_0/1
IEEE_ADDR_0
........
IEEE_ADDR_7
RX_SAFE_MODE
AACK_UPLD_RES_FT
AACK_FLTR_RES_FT
SLOTTED_OPERATION
Section 8.2 “Frame Check Sequence (FCS)” on page
Table 7-5 on page
Description
1: Enable promiscuous Mode
1: Disable generation of acknowledgment
Description
Set node addresses
0: disable frame protection
1: enable frame protection
1: Enable reserved frame type reception
Filter reserved frame types like data frame type,
see note below
0: disable
1: enable
0: if transceiver works in unslotted mode
1: if transceiver works in slotted mode
54, should be set to their reset values.
Section 8.1.2.2 “Frame Control
AT86RF231
85). The
58
Related parts for AT86RF231
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
Part Number:
Description:
INTERVAL AND WIPE/WASH WIPER CONTROL IC WITH DELAY
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
Low-Voltage Voice-Switched IC for Hands-Free Operation
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
MONOLITHIC INTEGRATED FEATUREPHONE CIRCUIT
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
AM-FM Receiver IC U4255BM-M
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
Monolithic Integrated Feature Phone Circuit
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
Multistandard Video-IF and Quasi Parallel Sound Processing
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
High-performance EE PLD
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
8-bit Flash Microcontroller
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
2-Wire Serial EEPROM
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
U6046BREAR WINDOW HEATING TIMER / LONG-TERM TIMER
Manufacturer:
ATMEL Corporation
Datasheet: