STEVAL-PCC010V2 STMicroelectronics, STEVAL-PCC010V2 Datasheet - Page 9

• Manufacturer Part Number: STEVAL-PCC010V2
• Description: BOARD EVAL FOR ST802RT1A
• Manufacturer: STMicroelectronics
• Series: -r

Specifications of STEVAL-PCC010V2

• Design Resources: STEVAL-PCC010V2 BOM STEVAL-PCC010V2 Schematic
• Main Purpose: Interface, Ethernet Controller (PHY and MAC)
• Embedded: Yes, MCU, 32-Bit
• Utilized Ic / Part: ST802RT1A, STM32F207
• Primary Attributes: 1 Port, 100BASE-TX/10BASE-T
• Secondary Attributes: MII, RMII
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 497-11465

UM1041
1.
Figure 4.
2.
3.
4.
5.
6.
Connect boards delivered in the package as shown in
Set up the jumpers on the ST802RT1A Ethernet PHY demonstration board. The
software does not change any settings of the PHY; it reads the settings from the PHY
instead. See
Connect ST802RT1A Ethernet PHY board to the STM32F207 controller demonstration
board.
Connect the Ethernet cable to the ST802RT1A Ethernet PHY board on one side and to
the PC on the other side.
Flash the demonstration software into the Flash of the STM32F207 MCU.
easy to set up any other operating system in a similar way.
a)
Configure the PC. The following description is valid for Windows
Set network settings: in control panel choose Network Connections, right click on
the network card, and open Properties.
ST802RT1A demonstration board connected to the STM32F207
demonstration board
Section 6.1
for more details of board setup.
Doc ID 18370 Rev 1
Figure
4:
®
XP; nevertheless it is
Getting started
9/34