M24C16-MN6T STMicroelectronics, M24C16-MN6T Datasheet - Page 12

• Manufacturer Part Number: M24C16-MN6T
• Description: EEPROM Serial-I2C 16K-Bit 2K x 8 5V 8-Pin SO N T/R
• Manufacturer: STMicroelectronics

Specifications of M24C16-MN6T

• Package: 8SO N
• Interface Type: Serial-I2C
• Density: 16 Kb
• Maximum Operating Frequency: 0.4 MHz
• Maximum Random Access Time: 900 ns
• Typical Operating Supply Voltage: 5 V
• Organization: 2Kx8
• Data Retention: 40(Min) Year
• Hardware Data Protection: Yes
• Operating Temperature: -40 to 85 °C

M24C16, M24C08, M24C04, M24C02, M24C01
Sequential Read
This operation can be used after a Current Ad-
dress Read or a Random Address Read. The bus
master does acknowledge the data byte output,
and sends additional clock pulses so that the de-
vice continues to output the next byte in sequence.
To terminate the stream of bytes, the bus master
must not acknowledge the last byte, and must
generate a Stop condition, as shown in
The output data comes from consecutive address-
es, with the internal address counter automatically
incremented after each byte output. After the last
memory address, the address counter ‘rolls-over’,
and the device continues to output data from
memory address 00h.
12/29
Figure
9..
Acknowledge in Read Mode
For all Read commands, the device waits, after
each byte read, for an acknowledgment during the
9
Data (SDA) Low during this time, the device termi-
nates the data transfer and switches to its Stand-
by mode.
INITIAL DELIVERY STATE
The device is delivered with the memory array
erased: all bits are set to 1 (each byte contains
FFh).
th
bit time. If the bus master does not drive Serial